Advanced 3D-Printed Biopolymer-Based Composites
A special issue of Polymers (ISSN 2073-4360). This special issue belongs to the section "Biomacromolecules, Biobased and Biodegradable Polymers".
Deadline for manuscript submissions: 31 December 2024 | Viewed by 22
Special Issue Editor
Interests: wood; bamboo; lignocellulosic materials; natural fibers-reinforced composites; thermal modification; the structural design; fused deposition modeling (FDM)
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Additive manufacturing (AM), commonly known as 3D printing, has been a promising technology in various applications, such as aeronautics, civil engineering, automotive engineering, and medicine. Compared to traditional subtractive manufacturing, AM enables the automatic fabrication of products or functional components with complex shapes at a low manufacturing cost. In addition, the development of environmentally sustainable products from biomass and lower chemical consumption are required by the 3D printing technique. Natural-derived biopolymers, including cellulose, hemicellulose, lignin, starch, alginate, and chitosan, are widely available, biodegradable, biocompatible, renewable, and inherently functional. On the other hand, natural fibers have various advantages, including good mechanical properties, low density, and a reduction in cost. The aim of this Special Issue is to investigate the application and development of advanced 3D printing biopolymer-based composites. Authors are invited to submit original research articles on novel, functional, and environmentally sustainable biocomposite materials for 3D printing
Dr. Teng-Chun Yang
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Polymers is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2700 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- additive manufacturing
- biopolymers
- biocomposites
- filament improvement
- functional materials
- 3D printing technologies
- structural design
