**Contents**


## **About the Editors**

**Veeriah Jegatheesan** is a Professor of Environmental Engineering at RMIT University, Melbourne, Australia. Jega is the founder and Chairman of the international conference series on Challenges in Environmental Science & Engineering (CESE), which has been held annually since 2008. Jega has conducted extensive research into various applications of membranes. He has over 450 publications, including more than 170 peer-reviewed journal articles and 5 edited books. In 2019, the Stormwater Industry Association (Australia) appointed him as one of the Governance Panel members for the Australian Stormwater Quality Improvement Device Evaluation Protocol (SQIDEP). Jega is the Editor-In-Chief of a book series entitled Applied Environmental Science and Engineering (AESE) for a Sustainable Future, published by Springer. Jega has been the Editor-in-Chief of the Environmental Quality Management journal (Wiley Publisher) since January 2020.

**Chettiyappan Visvanathan** is a Professor of the Environmental Engineering and Management Program, School of Environment, Resources and Development, Asian Institute of Technology. He has a Ph.D. in Chemical/Environmental Engineering from Institute National Polytechnique, Toulouse, France. His main areas of research interests include membrane technologies for water and wastewater treatment, cleaner production and solid waste disposal and management. In the field of membrane technology, his main research interests focus on the development of MBR systems (both aerobic and anaerobic), water recycling and industrial wastewater treatment. He has published more than 150 international journal papers and has more than 30 years of experience teaching environmental engineering and management-related courses at graduate level at AIT. His professional experiences include acting as a Project Engineer for the Asia Division, the International Training Center for Water Resources Management, Sophia Antipolis, France, and a being short-term consultant for the UNEP Industry and Environment Office, Paris, France.

**Li Shu** is an Adjunct Associate Professor at Edith Cowan University, Australia and the Managing Director of LJS Environment, Australia. She is a Guest Professor at Shandong Normal University. Li has more than 150 publications. She, along with her students and colleagues, was the first to document images of water clusters taken by a microscope. They also proposed the structure of water. With this proposed structure of water, water's mysterious behaviors could be explained. Li's research interest is in water and wastewater treatment using membranes, in addition to resource recovery and zero liquid discharge. She taught Water and Wastewater Systems to undergraduate and post graduate students. She is one of the founders of an International Conference "Challenges in Environmental Science and Technology", CESE, and has been the Co-Chair of the Conference since 2008. She is an Editorial Board Member and a Guest Editor of many prestigious journals.

**Faisal I. Hai** is the director of the Strategic Water Infrastructure Lab (SWIL) and the coordinator of the 'Environmental Engineering and Water Resources Powerhouse' of the University of Wollongong, Australia. He is an executive board member of the Membrane Society of Australasia. Professor Hai is an Editor of 'Water Science and Technology' (IWA, UK) and 'Journal of Water and Environment Technology' (Japan Society on Water Environment) and a member of the Editorial Board of numerous Elsevier journals. He is the lead editor of 'Membrane Biological Reactors', one of the bestsellers from IWA publishing, UK. A recognized authority in advanced wastewater treatment and reuse, Prof Hai has forged strong collaborations with industry and internationally leading researchers, which have led to collaborative grants and/or high-caliber publications.

**Ludovic F. Dum´ee** is an Assistant Professor of Separation Materials within the department of Chemical Engineering at Khalifa University, and is interested in the development and application of advanced separation materials, primarily focusing on membranes and catalysts. His research interests concern the understanding of nanoscale interactions between contaminants and surfaces, as well as the design of reactive and stimuli-responsive materials in the water, gas and healthcare applications. His team is interested in the engineering and combinatorial inclusion of carbon allotropes and ceramics nano-coatings across metal and polymeric materials to control the texture and reactivity of separation materials at nanoscale. He also focuses on the development of innovative solutions to tackle challenges arising from emerging micro-pollutants, such as PFAS or microplastics, as well as the simultaneous separation and conversion of gases into fuels and monomers.

## *Editorial* **Applications of Membranes for Sustainability**

#### **Veeriah Jegatheesan 1,\*, Chettiyappan Visvanathan 2, Li Shu 3,4, Faisal I. Hai 5 and Ludovic F. Dumée 6**


Applications of membranes in water and wastewater treatment, desalination, as well as other purification processes, have become more widespread over the past few decades. However, we continue to ponder on (i) how well do we ge<sup>t</sup> maximum benefits from membrane applications? (ii) In what areas of membranes do we need to further our fundamental understanding? (iii) Which membrane technologies find difficulties in scaleup? (iv) How good are we in integrating membrane technologies? (v) How can we improve the reliability of membranes and reduce the cost? (vi) Where are we in disseminating the needs if we are to use membranes all over the world? (vii) How can we bring true global collaborations? The membrane community all over the world is continuing to contribute to answer those questions. This Special Issue is also contributing answers to some of the above questions. The call for papers for this Special Issue invited researchers broadly, and the delegates of the International Conference on the Challenges in Environmental Science and Engineering, CESE-2019 (3–7 November 2019, at the Grand Hi-Lai Hotel in Kaohsiung, Taiwan) in particular, who are working on the above to submit original research papers, critical review articles, case studies and technical notes.

Six articles investigating the performance of hybrid direct contact membrane distillation (DCMD)/UV photolysis and reverse osmosis (RO)/forward osmosis (FO) membranes, modification of membranes for photocatalysis and enhanced anti-bacterial properties, reviewing fouling of membrane bioreactors (MBRs) and predicting the fouling of MBRs are included in this collection. Tufail et al. [1] investigated the performance of hybrid DCMD and UV photolysis in degrading five trace organic contaminants (TrOCs). The study found that the nature and extent of the impact of inorganic ions, such as halides, nitrates and carbonates, as well as organic substance (humic acid), in degrading TrOCs depended on the type of TrOCs (phenolic contaminants such as bisphenol A and oxybenzone and non-phenolic contaminants such as sulfamethoxazole, carbamazepine, and diclofenac) and the concentration of the interfering ions. Thus, continued research is warranted to develop a database containing the performance of such a hybrid system in treating various TrOCs. Liyanaarachchi et al. [2] utilised FO to dilute RO concentrate, either to increase the water recovery from the RO system, or to discharge the diluted RO concentrate safely to the environment. They utilised the pre-treatment (sand filter) backwash water containing ferric hydroxide as the feed solution and RO concentrate as the draw solution for the FO process. The study found that cellulose triacetate (CTA) flat sheet FO membrane produced higher flux (3–6 L m<sup>−</sup><sup>2</sup> <sup>h</sup>−1) compared to that produced by polyamide (PA) hollow fibre FO membrane (less than 2.5 L m<sup>−</sup><sup>2</sup> <sup>h</sup>−1) under the same experimental conditions. Long-term studies conducted on the flat sheet FO membranes showed that fouling due to ferric hydroxide

1

**Citation:** Jegatheesan, V.; Visvanathan, C.; Shu, L.; Hai, F.I.; Dumée, L.F. Applications of Membranes for Sustainability. *Membranes* **2021**, *11*, 629. https:// doi.org/10.3390/membranes11080629

Received: 6 August 2021 Accepted: 13 August 2021 Published: 16 August 2021

**Publisher's Note:** MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations.

**Copyright:** © 2021 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https:// creativecommons.org/licenses/by/ 4.0/).

sludge did not allow the water flux to increase more than 3.15 L m<sup>−</sup><sup>2</sup> h−1. Increasing the water flux needs further investigation in order for the process to have practical applications.

Sakakar et al. [3] synthesised thin-film composite (TFC) polyvinylidene fluoride (PVDF) membranes by coating with titanium dioxide (TiO2)/polyvinyl alcohol (PVA) solution through the dip-coating method, and cross-linked it with glutaraldehyde to improve the thermal and chemical stability of the thin film coating. The study found that the layer of TiO2 nanoparticles on the PVDF membranes reduced the fouling effects compared to the plain PVDF membrane. The study also showed that nearly 78% methyl orange and 47% reactive blue dyes were removed by the TFC membrane, along with photodegradation. However, the membrane can be damaged by the radicals formed by TiO2 during UV irradiation. Further studies are required to improve the stability of the membrane by finding suitable polymers or using inorganic membranes which are less susceptible to the attack by the radicals. Samree et al. [4] modified the PVDF membrane by coating it with nanoparticles of titanium dioxide (TiO2-NP) and silver (Ag-NP) at different concentrations and coating times to improve the hydrophilicity and antibacterial properties of the membrane. The study compared both the plain and modified PVDF membrane with respect to their performance in reducing Escherichia coli cells and inhibiting the formation of biofilm on the membrane surface. Compared to plain PVDF membrane, the modified membrane exhibited antibacterial efficiency up to 94% against E. coli cells, and inhibition up to 65% of the biofilm mass reduction.

Du et al. [5] carried out an extensive review on the mechanisms, impacts and control methods of membrane fouling in MBR systems. Compared to conventional activated sludge process, an MBR has many advantages, such as good effluent quality, small floor space, low residual sludge yield and easy automatic controls. It also allows slow growing microbes to exist and therefore remove hardly degradable pollutants. The treated effluent by MBR will generally meet Class A standards and therefore can be reused in various applications. However, membrane fouling is the main obstacle to the wider application of MBR. The authors sugges<sup>t</sup> focussing the future research on the following: (i) Exploring real-time formation of organic fouling of membranes to optimise periodic cleaning. (ii) Developing new membranes with increased anti-fouling properties; low energy consumption, less chemical usage, and easier operation and maintenance should also be researched. Comprehensive economic analysis, life cycle assessment, and carbon footprint analysis of different direct membrane filtration processes should be conducted in order to identify the most suitable system configuration for further scale-up. (iii) Finding hybrid methods with low energy consumption for improving the application of ultrasonic technology in full-scale MBR systems. (iv) Optimising the aeration; the method of aeration could be optimized according to computational fluid dynamic modeling on the fluidization and the scouring behavior of the particles in MBRs. Moreover, the attachment tendency of biofilm colonizers on the medium and membranes should be assessed. Shi et al. [6] explored the recent advances in predicting the fouling of MBRs. They reviewed the techniques available to predict fouling in MBRs and discussed the problems associated with predicting fouling status using artificial neural networks and mathematical models. The authors sugges<sup>t</sup> that the following need further research: (i) Fouling mechanisms in MBRs of different structures and scales with the development of accurate and real-time online data on membrane fouling. (ii) Study on remaining useful life (RUL) predictions of the membrane modules at various failure modes, as failure of membrane modules is usually caused by the synergistic effect of multiple failure modes. (3) Intelligent feature extraction by deep learning, such as a deep belief network and convolutional neural network.

Thus, the articles provided in this Special Issue disseminate both the current knowledge available and future research needs in the respective topics discussed. We hope this collection will be useful for developing plans for future research topics on the applications of membranes for sustainability.

**Funding:** This research received no external funding. **Acknowledgments:** The gues<sup>t</sup> editors are grateful to all the authors that contributed to this Special Issue.

**Conflicts of Interest:** The gues<sup>t</sup> editors declare no conflict of interest.
