Skip to Content
SensorsSensors
  • Article
  • Open Access

31 July 2023

13 Pages

Positioning System of Infrared Sensors Based on ZnO Thin Film

,
,
and
1
Department of Materials Engineering, National Pingtung University of Science and Technology, Pingtung 912, Taiwan
2
Department of Chemical Engineering, King Mongkut’s University of Technology Thonburi, Bangkok 10140, Thailand
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue MEMS and NEMS Sensors

Abstract

Infrared sensors incorporating suspended zinc oxide (ZnO) pyroelectric films and thermally insulated silicon substrates are fabricated using conventional MEMS-based thin-film deposition, photolithography, and etching techniques. The responsivity of the pyroelectric film is improved via annealing at 500 °C for 4 h. The voltage response of the fabricated sensors is evaluated experimentally for a substrate thickness of 1 µm over a sensing range of 30 cm. The results show that the voltage signal varies as an inverse exponential function of the distance. A positioning system based on three infrared sensors is implemented in LabVIEW. It is shown that the position estimates obtained using the proposed system are in excellent agreement with the actual locations. In general, the results presented in this study provide a useful source of reference for the further development of MEMS-based pyroelectric infrared sensors.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.