Next Article in Journal
Evaluating the Role of Data Enrichment Approaches towards Rare Event Analysis in Manufacturing
Previous Article in Journal
Solar Heat Flux Suppression on Optical Antenna of Geosynchronous Earth Orbit Satellite-Borne Lasercom Sensor
 
 
Communication
Peer-Review Record

Dual-Band Antenna with Pattern and Polarization Diversity

Sensors 2024, 24(15), 5008; https://doi.org/10.3390/s24155008
by Jungmin Mo and Youngje Sung *
Reviewer 1: Anonymous
Reviewer 2:
Sensors 2024, 24(15), 5008; https://doi.org/10.3390/s24155008
Submission received: 4 July 2024 / Revised: 27 July 2024 / Accepted: 29 July 2024 / Published: 2 August 2024
(This article belongs to the Section Electronic Sensors)

Round 1

Reviewer 1 Report

Comments and Suggestions for Authors

An antenna with both pattern and polarization diversity is proposed in this manuscript. However, there are several problems.

1)“ Two of the ports exhibit orthogonal broadside radiation 10 patterns; the other two ports exhibit orthogonal conical radiation patterns.

How many ports are there in this antenna design

 

2)The format shown in Figure 4 is incorrect, and there is also Figure 9

 

3)In Figures 10 and 11, simulation data cannot be seen

 

4)“Isolation based on port positions”, Why not use isolation instead of using an electric field distribution diagram that is not intuitive

5)The references in the study lack relevant research from recent years, and most of the comparative literature is from 5 years ago.

Comments on the Quality of English Language

Minor editing of English language required

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

Comments and Suggestions for Authors

 

This work deals with the design of dual-band antenna with pattern and polarization diversity. Author had proposed a pattern-diversity antenna with different radiation patterns at two different frequency bands.

Author has to explain how he has designed and obtained the final proposed dimensions of the proposed antenna.

In the same time there is a difference between simulation and measurement results for reflection and isolation coefficients. Author has to explain why this difference.

For figure 10 and 11 author should plot the both results simulation and measurement permitting to compare them.

At the end author has to insert a Table comparing the proposed study with other studies published in literature.

 

 

Comments on the Quality of English Language

Minor editing of English language required

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Back to TopTop