Next Article in Journal
Improving Device Characteristics of Dual-Gate IGZO Thin-Film Transistors with Ar–O2 Mixed Plasma Treatment and Rapid Thermal Annealing
Next Article in Special Issue
Volumetric Scale-Up of a Packed-Bed Ion-Exchange System to Extract Phytate from Thin Stillage
Previous Article in Journal
Egg Yolk Oil as a Plasticizer for Polylactic Acid Films
Previous Article in Special Issue
A Systematic Study of Ammonia Recovery from Anaerobic Digestate Using Membrane-Based Separation
 
 
Article
Peer-Review Record

Coal-Fired Boiler Flue Gas Desulfurization System Based on Slurry Waste Heat Recovery in Severe Cold Areas

by Chenghu Zhang 1, Dezhi Zou 1,2,*, Xinpeng Huang 1,* and Weijun Lu 1
Reviewer 1:
Reviewer 2: Anonymous
Reviewer 3: Anonymous
Submission received: 29 November 2021 / Revised: 18 December 2021 / Accepted: 20 December 2021 / Published: 30 December 2021

Round 1

Reviewer 1 Report

Dear authors,

Comments are given in PDF file. Please check.

 

Comments for author File: Comments.pdf

Author Response

Please see the attachment

Author Response File: Author Response.pdf

Reviewer 2 Report

I send a pdf with the comments and suggestions for authors.

Comments for author File: Comments.pdf

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 3 Report

Comments and Suggestions for Authors

Dear Authors,

The Title:

 

Coal-fired boiler flue gas desulfurization system based on 2 slurry waste heat recovery in severe cold areas

 

I have to read your manuscript with great attention and interest. The material is consistent, comprehensive and complete.

The authors of the manuscript presented a theoretical model with a computational method for the wet flue gas desulphurization process. The cooperation system of the spray tower, open slurry pool and desulphurization system with heat recovery was developed.

 

The submission falls within the scope of the journal and is sufficiently original, and I have a remark, so I recommended the publication after MAJOR REVISIONS.

 

    1. Please explain all symbols and give explanations before Introduction  
    2. Read your work carefully as errors appear: see line 147, line 172, line 197, line 200, line 268, line 281, line 298, line 324, line 332, line 338, 339, 351, 365, etc.
  • improve the quality of the Fig. 4., Fig. 6., 7, 9, 10, 11, 12,13
  • Work out conclusions in the form of short points

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Round 2

Reviewer 3 Report

The authors referred to all comments and recommendations. I propose to accept the article for publication. 

Back to TopTop