Next Article in Journal
Development and Applications of Embedded Passives and Interconnects Employing Nanomaterials
Next Article in Special Issue
Synthesis and Characterization of Gold Chiral Nanoparticles Functionalized by a Chiral Drug
Previous Article in Journal
Structural and Transport Properties of E-Beam Sintered Lanthanide Tungstates and Tungstates-Molybdates
 
 
Article
Peer-Review Record

Deposition of Chiral Heptahelicene Molecules on Ferromagnetic Co and Fe Thin-Film Substrates

Nanomaterials 2022, 12(19), 3281; https://doi.org/10.3390/nano12193281
by Mohammad Reza Safari 1,2,*, Frank Matthes 1,2, Karl-Heinz Ernst 3,4, Daniel E. Bürgler 1,2,* and Claus M. Schneider 1,2,5
Reviewer 1:
Reviewer 2: Anonymous
Reviewer 3: Anonymous
Nanomaterials 2022, 12(19), 3281; https://doi.org/10.3390/nano12193281
Submission received: 11 August 2022 / Revised: 2 September 2022 / Accepted: 14 September 2022 / Published: 21 September 2022
(This article belongs to the Special Issue Chirality in Micro-Nanostructures and Physical Chemical Applications)

Round 1

Reviewer 1 Report

In this manuscript, the authors have reported their study on the deposition of chiral heptahelicene by sublimation under ultra-high vacuum onto bare Cu(111), Co bilayer nanoislands on Cu(111), and Fe bilayers on  W(110) by low-temperature spin-polarized scanning tunneling microscopy/spectroscopy. In all cases, the molecules remain intact and adsorb with the proximal phenanthrene group aligned parallel to the surface. Overall the manuscript is well organized and the language is global good. In my opinion, their work laid the foundation for studying CISS in ultra-high vacuum and on the microscopic level of single molecules in controlled atomic configurations. Thus, I recommend this manuscript published on nanomaterials as it is.  

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 2 Report

The authors present an interesting work on the interaction between electron spin and handedness of chiral molecules in surface-adsorbed chiral molecules. I have several questions need to be addressed to clarify my doubt.

 

1. The author should provide more information on the important of CISS effect to highlight the motivation of the work

2.  In the experimental work, author should provide the quantitative vacuum values to edge other reader to follow.

3. In the STM measurement, the author should explain why you do three different measurments. In the The dI/dV signal for the conductivity maps and point spectra, what is the important of the chosen frequencies of the envelop signal? Why do you select fmod = 875 of 752 Hz?

4. Do you develop the Gaussian filter method for post processing of the images captured by STM system or using the add-in provided by the system? What is the advantage compared to other existence methods?

5. Is the deposition control of [7]H molecules on Co/Cu(111) and Fe/W(110) substrate systems reproducible? Authors should provide evidence on this point to strengthen their conclusions.

6. Does the interaction between [7]H molecules and substrates depend on vacuum condition?

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Reviewer 3 Report

The authors study the deposition of chiral heptahelicene by sublimation under ultra-high vacuum onto Cu(111), Co(111), and Fe(110) b y low-temperature spin-polarized STM/STS. In general, the paper is of high value for reference and study with clear structure. However, here are some problems to be addressed before its acceptance.

1. Throughout the paper, the main characterization technique seems only STM/STS. Can the authors provide some diffraction results upon samples?

2. In Table I, the authors summarized the [7]H adsorption orientations on Cu(111), Co/Cu(111), and Fe/W(110). Perhaps, a histogram may be clearer and more direct?

3. In Figure A1, the authors mentioned high-resolution topographic image. In my opinion, the term “high-resolution TEM” is common. But how do the authors define a high-resolution topographic image?

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Back to TopTop