Search Results (7)

A series of novel indole derivatives containing ester groups, halogen, epoxy and short-chain aliphatic hydrocarbons were designed, synthesized and evaluated for their antibacterial activities. Most of the compounds showed relatively excellent inhibitory activities against different strains (including a multidrug-resistant clinical isolate). Compounds 3f, 3o and 3r showed the strongest inhibitory activity (mic of 2–32 μg/mL). Compounds 3f, 3h, 3i, 3o and 3r with antibacterial activity were not cytotoxic against RAW 264.7 mouse macrophages. The structure–activity relationship analysis and docking studies showed that the halogens as well as aliphatic hydrocarbons could enhance the antibacterial ability and reduce the toxicity of the indole compounds. Full article

The occurrences, distributions, and risks of 55 target volatile organic compounds (VOCs) in water, sediment, sludge, and soil samples taken from a chemical industrial park and the adjacent area were investigated in this study. The Σ₅₅-VOCs concentrations in the water, sediment, sludge, and soil samples were 1.22–5449.21 μg L⁻¹, ND–52.20 ng g⁻¹, 21.53 ng g⁻¹, and ND–11.58 ng g⁻¹, respectively. The main products in this park are medicines, pesticides, and novel materials. As for the species of VOCs, aromatic hydrocarbons were the dominant VOCs in the soil samples, whereas halogenated aliphatic hydrocarbons were the dominant VOCs in the water samples. The VOCs concentrations in water samples collected at different locations varied by 1–3 orders of magnitude, and the average concentration in river water inside the park was obviously higher than that in river water outside the park. However, the risk quotients for most of the VOCs indicated a low risk to the relevant, sensitive aquatic organisms in the river water. The average VOCs concentration in soil from the park was slightly higher than that from the adjacent area. This result showed that the chemical industrial park had a limited impact on the surrounding soil, while the use of pesticides, incomplete combustion of coal and biomass, and automobile exhaust emissions are all potential sources of the VOCs in the environmental soil. The results of this study could be used to evaluate the effects of VOCs emitted from chemical production and transportation in the park on the surrounding environment. Full article

Volatile organic compounds (VOCs), with negative impacts on the aquatic ecosystem, are increasingly released into the environment by anthropogenic activities. Water samples were collected from five areas of the Han River Watershed (HRW) tributaries, South Korea, to detect 11 VOCs, which were classified as halogenated aliphatic hydrocarbons (HAHs) and aromatic hydrocarbons (AHs). Among the 11 VOCs, 1,1-dichloroethylene, 1,1,1-trichloroethane, and vinyl chloride were undetected. The highest concentration compounds were chloroform (0.0596 ± 0.1312 µg/L), trichloroethylene (0.0253 ± 0.0781 µg/L), and toluene (0.0054 ± 0.0139 µg/L). The mean concentration (0.0234 µg/L) and detection frequency (37.0%) of HAHs were higher than those of AHs (0.0036 µg/L, 21.0%, respectively). The Imjin Hantan River area exhibited the highest mean concentration (0.2432 µg/L) and detection frequency (22.9%), because it is located near industrial complexes, thus, highlighting their role as important VOC sources. However, the detected VOCs had lower concentrations than those permitted by the EU, WHO, USA, and South Korea drinking water guidelines. Ecological risks associated with the VOCs were estimated by risk quotient (RQ); consequently, the predicted no-effect concentration was 0.0029 mg/L, and the toluene and styrene RQ values were >1 and >0.5, respectively. The findings may facilitate policymakers in designing pollution control strategies. Full article

Conventional asphalt mixtures used for road paving require high manufacturing temperatures and therefore high energy expenditure, which has a negative environmental impact and creates risk in the workplace owing to high emissions of pollutants, greenhouse gases, and toxic fumes. Reducing energy consumption and emissions is a continuous challenge for the asphalt industry. Previous studies have focused on the reduction of emissions without characterizing their composition, and detailed characterization of volatile organic compounds (VOCs) and semi-volatile organic compounds (SVOCs) in asphalt fumes is scarce. This communication describes the characterization and evaluation of VOCs and SVOCs from asphalt mixtures prepared at lower production temperatures using natural zeolite; in some cases, reclaimed asphalt pavement (RAP) was used. Fumes were extracted from different asphalt mix preparations using a gas syringe and then injected into hermetic gas sample bags. The compounds present in the fumes were sampled with a fiber and analyzed by gas-liquid chromatography coupled to mass spectrometry (GC/MS). In general, the preparation of warm mix asphalts (WMA) using RAP and natural zeolite as aggregates showed beneficial effects, reducing VOCs and SVOCs compared to hot mix asphalts (HMA). The fumes captured presented a similar composition to those from HMA, consisting principally of saturated and unsaturated aliphatic hydrocarbons and aromatic compounds but with few halogenated compounds and no polycyclic aromatic hydrocarbons. Thus, the paving mixtures described here are a friendlier alternative for the environment and for the health of road workers, in addition to permitting the re-use of RAP. Full article

The work is devoted to the chemical modification of a polymer that is promising for the creation of gas separation membranes, aimed at increasing the selectivity with respect to CO₂. The introduction of ionic liquids into the structure of poly(1-trimethylsilyl-1-propyne) is realized by a two-step process: bromination of the initial polymer with N-bromosuccinimide and subsequent addition of tertiary amine (N-butylimidazole) to it. Depending on the process conditions, the method allows polymers with different contents of the ionic liquid to be obtained. The obtained polymers show good film-forming properties and thermal stability. Depending on the content of the ionic liquid in the polymer matrix, the resistance to aliphatic alicyclic to the majority of halogenated, as well as aromatic hydrocarbons, increases. With an increase of the ionic liquid content in the polymer, the ideal selectivities of CO₂/N₂ and CO₂/CH₄ gas pairs increases while maintaining a high level of permeability. Full article

Carbon tetrachloride (CCl₄) is an efficient but highly toxic solvent, used in households and commercially in the industry under regulatory surveillance to ensure safety at the working place and to protect the workers’ health. However, acute unintentional or intentional intoxications by CCl₄ may rarely occur and are potentially life-threatening. In this review article, therapy options are discussed that are based on a literature review of traditional poisoning cases and the clinical experience with 16 patients with acute poisoning by CCl₄. Among various therapy options, the CO₂-induced hyperventilation therapy will be considered in detail as the most promising approach. This special therapy was developed because only around 1% of the intoxicating CCl₄ is responsible for the liver injury after conversion to toxic radicals via microsomal cytochrome P450 2E1 whereas 99% of the solvent will leave the body unchanged by exhalation. Therefore, to enhance CCl₄ elimination through the lungs, CO₂ is added to the inspiration air at a flow rate of 2–3 L min⁻¹ in order to achieve hyperventilation with a respiratory volume of 25–30 L min⁻¹. Under this therapy, the clinical course was favorable in 15/16 patients, corresponding to 93.8%. In essence, patients with acute CCl₄ intoxication should be treated by forced ventilation. Full article

Arrays with polymer-coated acoustic sensors, such as surface acoustic wave (SAW) and surface transverse wave (STW) sensors, have successfully been applied for a variety of gas sensing applications. However, the stability of the sensors’ polymer coatings over a longer period of use has hardly been investigated. We used an array of eight STW resonator sensors coated with different polymers. This sensor array was used at semi-annual intervals for a three-year period to detect organic solvent vapors of three different chemical classes: a halogenated hydrocarbon (chloroform), an aliphatic hydrocarbon (octane), and an aromatic hydrocarbon (xylene). The sensor signals were evaluated with regard to absolute signal shifts and normalized signal shifts leading to signal patterns characteristic of the respective solvent vapors. No significant time-related changes of sensor signals or signal patterns were observed, i.e., the polymer coatings kept their performance during the course of the study. Therefore, the polymer-coated STW sensors proved to be robust devices which can be used for detecting organic solvent vapors both qualitatively and quantitatively for several years. Full article