Search Results (2)

There are some problems in the application of slurry preparation technology, such as wide fluctuation range of underflow concentration, long settling time and low efficiency of solid–liquid separation. This is an important basis for researching the thick settling law of tailings slurry under the action of mechanical vibration and its influencing factors to solve these problems. To this end, a small vibration thickening testing machine and vibrating rod were designed and developed. Physical simulation experiments were conducted to analyze the settling characteristics of tailings slurry under different vibration duration, start time, vibration frequency, and vibration inertia single factors. The results show that: (1) Mechanical vibration can effectively accelerate the settling speed of tailings particles, but the relationship between them is a non-positive correlation, and mechanical vibration time control with in 5 mins is the best. With the delay of starting the vibration time, the final mass concentration first increases and then decreases. (2) As the vibration frequency increases, the final mass concentration of tailings settlement first increases and then decreases. When the eccentric vibrator speed is 6000 r/min, the best slurry settlement effect is achieved. (3) When the vibration inertia of the eccentric oscillator is 0.158 g·cm² and the final mass concentration reaches 70.1%, the settling time only takes 210 min. (4) The lower the slurry concentration, the faster the settling speed. As the initial concentration increases, the final thickening time is also gradually prolonged. The research results provide some insights for the rapid thickening technology of rake-free paste thickeners. Full article

Paste and thickened tailings (PTT) technology can improve the utilization and management of tailings from processing plants. The pore size distribution (PSD) and microstructure evolution affected by the rake shear in thickening tailings beds are essential to produce a high-density tailings underflow. Continuous thickening and computed tomography (CT) scanning tests were conducted to study the PSD with and without shear. The pore morphology was studied to reveal the shearing-dewatering performance of the tailings bed. The results show that at a flocculant solution concentration of 0.01 wt % and a feed slurry concentration of 10 wt%, the underflow concentration with and without shear can reach 58.5 wt %and 55.8 wt %, respectively. The CT image reconstruction models demonstrated that the porosity of the sheared tailings bed increased with the bed height. When the bed height increased from 2.5 to 10 cm, the porosity increased from 35.1% to 41.9%, the pore fractal dimension increased from the range 1.8–1.95 to the range 2.1–2.15, and the pore quantity decreased by 21.39%. The average pore volume increased with increasing height by 13.93%, 16.57% and 12.07%. The pore structure became more complex with the bed height, and the connectivity between pores increased to form water-flow channels, which were beneficial to the drainage of sealed water. Full article