Search Results (2)

The Quasi-Impedance-Source Inverter (Quasi-Z inverter) is an interesting DC-AC converter topology that can be used in applications such as fuel cells and photovoltaic generators. This topology allows for both boost capability and DC-side continuous input current. Another very interesting feature is its reliability, as it limits the current when two switches on one leg are conducting simultaneously. This is due to an extra conduction state, specifically the shoot-through state. However, the shoot-through state also causes a loss of performance, increasing electromagnetic interference and harmonic distortion. To address these issues, this work proposes a modified carrier-based control method for the T-Type single-phase quasi-Z inverter. The modified carrier-based method introduces the use of two additional states to replace the standard shoot-through state. The additional states are called the upper shoot-through and the lower shoot-through. An approach to minimize the number of switches that change state during transitions will also be considered to reduce switching losses, improving the converter efficiency. The proposed modified carrier-based control strategy will be tested using computer simulations and laboratory experiments. From the obtained results, the theoretical considerations are confirmed. In fact, through the presented results, it is possible to understand important improvements that can be obtained in the THD of the output voltage and load current. In addition, it is also possible to verify that the modified carrier method also reduces the input current ripple. Full article

The boost feature that characterizes Z-source and quasi-Z-source converters is usually achieved by means of a proper insertion of short-circuit states in the full DC-link. In this work, a novel pulse width modulation carrier-based strategy for a three-phase, three-level T-type, quasi-Z-source inverter is introduced, based on the addition of alternate short-circuits in the two halves of the DC-link bus. This technique achieves better performance, less electromagnetic interference, and lower harmonic distortion of the output line-to-line voltage compared to the traditional methods based on the full DC-link shoot-through. At the same time, generating the switching states is to easy implement. The proposed strategy permits the use of electronic devices with lower blocking voltage capability, thus improving converter reliability, size, and cost. The new method may be implemented in another multilevel inverter with an impedance-source network as well. A comprehensive simulation study is performed in order to validate the adopted method, with different inverter input voltages, which is taken as representative of a photovoltaic array. Comparisons are conducted with conventional strategy insertions using the same topology in order to show the improvements achieved. Full article