Next Article in Journal
Change Analysis in Structural Laser Scanning Point Clouds: The Baseline Method
Next Article in Special Issue
Software Defined Doppler Radar as a Contactless Multipurpose Microwave Sensor for Vibrations Monitoring
Previous Article in Journal
Experimental Investigations of a Precision Sensor for an Automatic Weapons Stabilizer System
Previous Article in Special Issue
Visualization of Venous Compliance of Superficial Veins Using Non-Contact Plethysmography Based on Digital Red-Green-Blue Images
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Correction

Correction: Lim, S., et al. Millimeter-Wave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity. Sensors 2016, 16, 1829

School of Electrical and Electronics Engineering, Chung-Ang University, 84 Heukseok-ro, Dongjak-gu, Seoul 156-756, Korea
*
Author to whom correspondence should be addressed.
Sensors 2017, 17(1), 29; https://doi.org/10.3390/s17010029
Submission received: 21 December 2016 / Revised: 21 December 2016 / Accepted: 22 December 2016 / Published: 24 December 2016
(This article belongs to the Special Issue Non-Contact Sensing)
We wish to make the following corrections to their paper [1]:
The title of the paper ‘Millimeter-Wave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity’ should be changed to ‘Microwave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity’.
In the second line of the abstract, on the fifth line of Section 3 (Simulation Results), and in Section 4 (Experimental Demonstration) on Page 7, the phrase ‘millimeter-wave frequency range’, should be changed to ‘microwave frequency range’. Also, on the third line of the Conclusion Section, ‘millimeter-wave’, should be replaced with ‘microwave’.
It is well-known that millimeter-wave corresponds to a frequency of over 30 GHz. As the proposed sensor functions at around 18 GHz, it should be called ‘microwave’. We apologize for any inconvenience these changes have caused to readers. The changes do not affect the scientific results. The manuscript will be updated and the original will remain online on the article webpage.

Conflicts of Interest

The authors declare no conflict of interest.

Reference

  1. Memon, M.U.; Lim, S. Millimeter-Wave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity. Sensors 2016, 16, 1829. [Google Scholar] [CrossRef] [PubMed]

Share and Cite

MDPI and ACS Style

Memon, M.U.; Lim, S. Correction: Lim, S., et al. Millimeter-Wave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity. Sensors 2016, 16, 1829. Sensors 2017, 17, 29. https://doi.org/10.3390/s17010029

AMA Style

Memon MU, Lim S. Correction: Lim, S., et al. Millimeter-Wave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity. Sensors 2016, 16, 1829. Sensors. 2017; 17(1):29. https://doi.org/10.3390/s17010029

Chicago/Turabian Style

Memon, Muhammad Usman, and Sungjoon Lim. 2017. "Correction: Lim, S., et al. Millimeter-Wave Chemical Sensor Using Substrate-Integrated-Waveguide Cavity. Sensors 2016, 16, 1829" Sensors 17, no. 1: 29. https://doi.org/10.3390/s17010029

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop