Next Article in Journal
Relative Humidity Fiber Sensor Based on Multimode Interferometer Coated with Agarose-Gel
Previous Article in Journal
Effects of Low-Temperature Tempering on Microstructure and Properties of the Laser-Cladded AISI 420 Martensitic Stainless Steel Coating
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Correction

Correction: Awino, C., et al. Investigation of Structural and Electronic Properties of CH3NH3PbI3 Stabilized by Varying Concentrations of Poly(Methyl Methacrylate) (PMMA). Coatings 2017, 7, 115

1
Helmholtz-Zentrum Berlin, Institut für Si-Photovoltaik, Kekuléstr. 5, D-12489 Berlin, Germany
2
Department of Physics, School of Natural Sciences, Masinde Muliro University of Science and Technology, P.O. Box 190-50100, Kakamega, Kenya
3
Department of Physics, School of Physical Sciences, University of Nairobi, P.O. Box 30197-00100, Nairobi, Kenya
4
Department of Materials Science, Faculty of Science, Kasetsart University, Bangkok 10900, Thailand
*
Authors to whom correspondence should be addressed.
Coatings 2018, 8(12), 452; https://doi.org/10.3390/coatings8120452
Submission received: 4 December 2018 / Accepted: 4 December 2018 / Published: 7 December 2018
In the original version of article [1], the lists of authors and affiliations, and the Acknowledgements and Author Contributions were incomplete. The manuscript was written by the co-authors, however the original version, the concept for the experiments, the initial experiments, extended supervision for continuation of experiments, and detailed and numerous discussions and explanations were provided by Dr. Pongthep Prajongtat, Dr. Thomas Dittrich and Prof. Dr. Bernd Rech. These people thus qualify for authorship and are added to the list of authors. All experiments were performed during a scholarship of the corresponding author at the Helmholtz-Zentrum Berlin.
The correct author list, Acknowledgements and Author Contributions are as follows:
Celline Awino 1,2,*, Victor Odari 2,3,*, Thomas Dittrich 1, Pongthep Prajongtat 4, Thomas Sakwa 2 and Bernd Rech 1
1 Helmholtz-Zentrum Berlin, Institut für Si-Photovoltaik, Kekuléstr. 5, D-12489 Berlin, Germany; [email protected] (T.D.); [email protected] (B.R.)
2 Department of Physics, School of Natural Sciences, Masinde Muliro University of Science and Technology, P.O. Box 190-50100, Kakamega, Kenya; [email protected]
3 Department of Physics, School of Physical Sciences, University of Nairobi, P.O. Box 30197-00100, Nairobi, Kenya
4 Department of Materials Science, Faculty of Science, Kasetsart University, Bangkok 10900, Thailand; [email protected]
* Correspondence: Correspondence: [email protected] (C.A.); [email protected] (V.O.); Tel.: +254-725-863-526 (C.A.); +254-723-927-357 (V.O.)
Acknowledgements: C.O. is grateful to the KAAD (Katholischer Akademischer Austauschdienst) for financial support. P.P. is grateful to the Development and Promotion of Science and Technology Talent Project (DPST, Thailand) for financial support. The authors are grateful to M. Lux-Steiner for providing laboratories and for discussions during the beginning of the project at the former Institute of Heterogeneous Materials of the Helmholtz-Zentrum Berlin.
Author Contributions: Conceptualization: Thomas Dittrich and Pongthep Prajongtat; Methodology: Pongthep Prajongtat, Thomas Dittrich and Celline Awino; Validation: Thomas Dittrich, Pongthep Prajongtat and Celline Awino; Formal Analysis: Celline Awino and Thomas Dittrich; Investigation: Celline Awino, Thomas Dittrich and Pongthep Prajongtat; Resources: all materials, devices and laboratories were provided by the Helmholtz-Zentrum Berlin; Writing-Original Draft: Celline Awino, Victor Odari and Thomas Sakwa; Writing-Review & Editing: Victor Odari, Thomas Sakwa and Celline Awino; Supervision: Bernd Rech and Thomas Dittrich; Project Administration: Bernd Rech; Funding Acquisition: Celline Awino.
The corresponding author apologizes for incomplete information in the original manuscript. The change does not affect the scientific results. The manuscript will be updated and the original will remain available. A link to this Correction will be added.

Reference

  1. Awino, C.; Odari, V.; Sakwa, T. Investigation of Structural and Electronic Properties of CH3NH3PbI3 Stabilized by Varying Concentrations of Poly(Methyl Methacrylate) (PMMA). Coatings 2017, 7, 115. [Google Scholar] [CrossRef]

Share and Cite

MDPI and ACS Style

Awino, C.; Odari, V.; Dittrich, T.; Prajongtat, P.; Sakwa, T.; Rech, B. Correction: Awino, C., et al. Investigation of Structural and Electronic Properties of CH3NH3PbI3 Stabilized by Varying Concentrations of Poly(Methyl Methacrylate) (PMMA). Coatings 2017, 7, 115. Coatings 2018, 8, 452. https://doi.org/10.3390/coatings8120452

AMA Style

Awino C, Odari V, Dittrich T, Prajongtat P, Sakwa T, Rech B. Correction: Awino, C., et al. Investigation of Structural and Electronic Properties of CH3NH3PbI3 Stabilized by Varying Concentrations of Poly(Methyl Methacrylate) (PMMA). Coatings 2017, 7, 115. Coatings. 2018; 8(12):452. https://doi.org/10.3390/coatings8120452

Chicago/Turabian Style

Awino, Celline, Victor Odari, Thomas Dittrich, Pongthep Prajongtat, Thomas Sakwa, and Bernd Rech. 2018. "Correction: Awino, C., et al. Investigation of Structural and Electronic Properties of CH3NH3PbI3 Stabilized by Varying Concentrations of Poly(Methyl Methacrylate) (PMMA). Coatings 2017, 7, 115" Coatings 8, no. 12: 452. https://doi.org/10.3390/coatings8120452

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop