Advances in Welding Processes of Metallic Materials
A special issue of Metals (ISSN 2075-4701). This special issue belongs to the section "Welding and Joining".
Deadline for manuscript submissions: 30 August 2024 | Viewed by 103
Special Issue Editor
Interests: ultrasonic soldering/brazing; acoustics; cavitation; cavitation erosion; welding
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Welding and joining, as the earliest connection methods used by human beings, have been used for a very long time. Welding and joining are widely used in various fields and have received great attention in recent years due to the development of aviation, aerospace, nuclear energy, electronics and other new technologies.
This Special Issue, titled “Advances in Welding Processes of Metallic Materials”, welcomes welding and joining processes of all kinds of materials. The following aspects are considered: process optimization; experiments; simulation; metallurgical behavior; intermetallic compound; fracture behaviors of all joints welded/joined using all kinds of welding methods.
Dr. Zhengwei Li
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Metals is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- welding
- joining
- soldering
- joint
- failure
Planned Papers
The below list represents only planned manuscripts. Some of these manuscripts have not been received by the Editorial Office yet. Papers submitted to MDPI journals are subject to peer-review.
Title: Numerical modeling of the process of connecting copper wires
Authors: Zygmunt Mikno; Janusz Pikuła
Affiliation: Lukasiewicz Research Network - Upper Silesian Institute
of technology, Welding Centre
