Research on a Distributed Calibration Method Based on Specific Force Measurement
![](/bundles/mdpisciprofileslink/img/unknown-user.png)
Round 1
Reviewer 1 Report
The paper is easy to read, concise and specific in its proposal. However, I have the following comments and suggestions:
1) Although throughout the article the proposal and contribution of the research are clear, the introduction section is not clear or explicit. In addition, an exhaustive study of the state of the art and the comparison between the proposal and the existing methods are not made. I suggest restructuring the Introduction section.
2) The conclusion needs a brief discussion of the most relevant hard data obtained in the research, to give greater robustness and validity to the findings.
Author Response
Dear reviewer, my reply has been placed in the attachment, please refer to the attachment.
Author Response File: Author Response.docx
Reviewer 2 Report
This paper talks about error correction methods and algorithms in the output of inertia sensors used in a batch. The papers has offered a reasonable mathematical treatment to address the problem and towards its solution.
Correct the error of reference on page 7, line 206.
Author Response
Dear reviewer, my reply has been placed in the attachment, please refer to the attachment.
Author Response File: Author Response.docx