Trials were conducted in 2018 and 2020 in a commercial orchard in Edneyville, NC. Trees were trained to vertical axis and received plant protectant sprays that adhered to local recommendations throughout the growing season.
2.1. Experiment 1: 2018
The experiment was conducted in a mature block of ‘Fugachee Fuji’/‘G.11’ planted at 2.1 × 4.3 m spacing. Reflective groundcovers were installed ~5 weeks before harvest. Woven reflective groundcovers (Beltech PD-2911 and Extenday®; 3.5 m width) were placed adjacent to 7-tree plots (15.2 m. long section) on each side of the row. Woven reflective groundcovers were secured to the ground using landscape staples. Mylar reflective groundcover (1 m width) was placed adjacent to 7-tree plots on each side of the row and positioned proximally to the drip line. Untreated control plots (sod groundcover) were included for comparison. To minimize edge effects, data were collected from trees in the center of plot. Specifically, two trees per plot with uniform crop load and canopy volume were selected (12 trees per treatment; 48 trees total).
Incident light and reflectance were quantified in the middle of the drive row (mid-row) and within the tree canopy. Measurements occurred 1.5 m above the ground on the north and south sides of the tree. Measurements were conducted on two mid-row positions and two trees from each plot (48 trees total). Incoming photosynthetically active radiation (PAR; 400–700 nm) and reflectance by groundcovers was quantified using a ceptometer (AccuPAR PAR/LAI Ceptometer Model LP-80; Decagon Devices Inc., Pullman, WA, USA). PAR measurements occurred proximally to solar noon on a cloud-free day. The ceptometer was held in a horizontal position for all measurements. Incident light was determined with ceptometer sensors oriented toward the sky. Light reflectance was quantified by inverting the sensor (facing the ground) at each at each position and direction. In-canopy measurements were carried out with the distal end of the ceptometer next to the trunk. Similarly, incoming UV radiation and reflectance (250–400 nm) was quantified using a UV250–400 meter and sensor (LightScout UV Meter and Sensor; Spectrum Technologies, Inc., Plainfield, IL, USA). Measurements occurred at the same mid-row and canopy positions described above. In-canopy measurements were performed with the UV250–400 meter positioned 15 cm from the trunk.
At commercial maturity, 30 August 2018, apples were harvested for yield and fruit quality assessments. Fruit were harvested from two trees per plot that had a uniform crop load and canopy volume. Early strains of ‘Fuji’ require multiple harvests, since fruit do not ripen uniformly. A second harvest was completed one week after the first. Fruit was placed in labelled containers and transported to the Mountain Horticultural Crops Research and Extension Center in Mills River, NC, USA (lat. 35.428079° N, long. 82.563295° W, elevation 649 m) for analysis.
Whole-tree yield, average fruit weight, fruit size distribution, percent (%) red fruit color (i.e., blush), and internal fruit quality were determined with an electronic fruit sorter (Durand-Wayland, Inc., LaGrange, GA, USA) outfitted with a color and infrared camera system and full transmittance spectrometer (TrueSort Electronics; Ellips, Eindhoven, The Netherlands).
At the first harvest date, 30 fruits per plot (180 fruit for each treatment; 720 fruit total) were sampled for fruit quality analysis. A benchtop colorimeter (ColorFlex EZ; Hunter Associates Laboratory, Reston, VA, USA) was used to quantify lightness, chroma, and hue. Two colorimeter measurements per fruit occurred near the equatorial region of the apple. Measurements occurred on the sun-exposed and shaded portion of the fruit peel of each fruit. Fruit were visually evaluated and incidence of sunburn was recorded. Fruit firmness was measured with a fruit texture analyzer (Güss GS-20; QA Supplies, Norfolk, VA, USA). Juice samples were collected during firmness ratings and soluble solids concentration were measured with a digital refractometer (model PR-32 alpha; Atago, Bellevue, WA, USA). Fruit was then cut at the equator and dipped in an iodine solution. Iodine staining patterns were evaluated in accordance with the Generic Cornell Starch-Iodine Index Chart for apples [
14].
Using information collected from the electronic fruit sorter (fruit color, fruit size, and yield) and FOB pricing data from a local apple packer-shipper, a partial economic analysis was conducted to determine crop value. Costs of groundcovers, mounting supplies, and labor were not included in this analysis.
2.2. Experiment 2: 2020
This experiment was conducted in a mature block of ‘DT2’ Aztec Fuji®/‘M.9’ planted at 1.5 × 4.3 m spacing. Reflective groundcovers were installed ~5 weeks before harvest. Woven reflective groundcovers (Extenday® DayBright, Lumilys™ WH100, and Belton experimental) were placed adjacent to 10 tree plots (15.2 m long section) on each side of the row. Woven reflective groundcovers were secured according to manufacturer recommendations. Untreated control plots (sod groundcover) were included for comparison. To minimize edge effects, data was collected from trees in the center of plot.
Incident light and reflectance of PAR and UV250–400nm radiation quantified on a single mid-row position on east and west sides of the tree from each plot as in the previous experiment. In-canopy light measurements were not performed in 2020. At commercial maturity, 1 October 2020, apples were harvested for yield and fruit quality assessments. Fruit was harvested from one tree per plot that had a uniform crop load and canopy volume (5 trees per treatment; 20 trees total), placed in labelled containers and transported to the Mountain Horticultural Crops Research and Extension Center in Mills River, NC, USA to be evaluated with an electronic fruit sorter as in the previous experiment. Fruit quality analysis was completed as previously reported with 20 fruit per plot (100 fruit for each treatment; 400 fruit total). Partial economic analysis was conducted as described in Experiment 1.