Next Article in Journal
IDeS (Industrial Design Structure) Method Applied to the Automotive Design Framework: Two Sports Cars with Shared Platform
Next Article in Special Issue
Waste Plastic Direct Extrusion Hangprinter
Previous Article in Journal / Special Issue
Development of a Multicolor 3D Printer Using a Novel Filament Shifting Mechanism
 
 
Article
Peer-Review Record

Calibration Dependencies and Accuracy Assessment of a Silicone Rubber 3D Printer

by Laszlo Jaksa 1,2,*, Dieter Pahr 2,3, Gernot Kronreif 1 and Andrea Lorenz 1
Reviewer 1: Anonymous
Reviewer 2:
Reviewer 3: Anonymous
Submission received: 19 March 2022 / Revised: 30 March 2022 / Accepted: 31 March 2022 / Published: 4 April 2022
(This article belongs to the Special Issue Innovations in 3D Printing 2.0)

Round 1

Reviewer 1 Report

A submission on 3D printing silicone rubber.

The literature review section can be improved.

Author Response

Thank you for your comments and suggestions. Please see the attachment. 

Author Response File: Author Response.pdf

Reviewer 2 Report

Page 1 line 42 - should be off-the-shelf

Page 3 line 109 - "system is available in …" missing text - it appears all in text citations are missing

The paper is well written and provides good knowledge. No major revisions required.

Author Response

Thank you for your comments and suggestions. Please see the attachment. 

Author Response File: Author Response.pdf

Reviewer 3 Report

Please see attached pdf

Comments for author File: Comments.pdf

Author Response

Thank you for your comments and suggestions. Please see the attachment. 

Author Response File: Author Response.pdf

Back to TopTop