State-of-the-Art Sensors Technology in Canada 2018

Parkinson’s disease (PD) is one of the leading neurological disorders in the world with an increasing incidence rate for the elderly. Freezing of Gait (FOG) is one of the most incapacitating symptoms for PD especially in the later stages of the disease. FOG is a short absence or reduction of ability to walk for PD patients which can cause fall, reduction in patients’ quality of life, and even death. Existing FOG assessments by doctors are based on a patient’s diaries and experts’ manual video analysis which give subjective, inaccurate, and unreliable results. In the present research, an automatic FOG assessment system is designed for PD patients to provide objective information to neurologists about the FOG condition and the symptom’s characteristics. The proposed FOG assessment system uses an RGB-D sensor based on Microsoft Kinect V2 for capturing data for 5 healthy subjects who are trained to imitate the FOG phenomenon. The proposed FOG assessment system is called “Kin-FOG”. The analysis of foot joint trajectory of the motion captured by Kinect is used to find the FOG episodes. The evaluation of Kin-FOG is performed by two types of experiments, including: (1) simple walking (SW); and (2) walking with turning (WWT). Since the standing mode has features similar to a FOG episode, our Kin-FOG system proposes a method to distinguish between the FOG and standing episodes. Therefore, two general groups of experiments are conducted with standing state (WST) and without standing state (WOST). The gradient displacement of the angle between the foot and the ground is used as the feature for discriminating between FOG and standing modes. These experiments are conducted with different numbers of FOGs for getting reliable and general results. The Kin-FOG system reports the number of FOGs, their lengths, and the time slots when they occur. Experimental results demonstrate Kin-FOG has around 90% accuracy rate for FOG prediction in both experiments for different tasks (SW, WWT). The proposed Kin-FOG system can be used as a remote application at a patient’s home or a rehabilitation clinic for sending a neurologist the required FOG information. The reliability and generality of the proposed system will be evaluated for bigger data sets of actual PD subjects. Full article

In this paper, a miniaturized Ultra High Frequency Radio Frequency Identification (UHF-RFID) tag-based sensor antenna using a magneto- dielectric substrate (MDS) for wireless identification and sensor applications is presented. Two models of RFID tag-based sensors are designed, fabricated and measured. The first model uses two RFID tags; both of the tags are incorporated with two RFID chips. A passive sensor is also integrated in one of the proposed tags to serve as a sensor node, while the other tag is used as a reference node. Based on the difference in the minimum power required to activate the reference and sensor nodes, the sensed data (temperature or humidity) can be determined. The magneto-dielectric substrate layer is placed underneath the patch antenna to reduce the size of the proposed sensor by about 75% compared to a conventional RFID tag-based sensor. The magneto-dielectric layer is thin enough to embed in the planer circuit. To reduce the size of the proposed sensor, a multi-port tag for including the reference and sensor node in one antenna is also presented. The proposed RFID tag-based sensors have several features such as small size, they are completely capable for two objectives at the same time and easy to integrate with a planer circuit. Full article

We report here a novel electrochemical sensor developed using fluorine-doped graphene oxide (F-GO) for the detection of caffeic acid (CA). The synthesized graphene oxide (GO) and F-GO nanomaterials were systematically characterized with a scanning electron microscope (SEM), and the presence of semi-ionic bonds was confirmed in the F-GO using X-ray photoelectron spectroscopy. The electrochemical behaviours of bare glassy carbon electrode (GCE), F-GO/GCE, and GO/GCE toward the oxidation of CA were studied using cyclic voltammetry (CV), and the results obtained from the CV investigation revealed that F-GO/GCE exhibited the highest electrochemically active surface area and electrocatalytic activity in contrast to the other electrodes. Differential pulse voltammetry (DPV) was employed for the analytical quantitation of CA, and the F-GO/GCE produced a stable oxidation signal over the selected CA concentration range (0.5 to 100.0 μM) with a low limit of detection of 0.018 μM. Furthermore, the acquired results from the selectivity studies revealed a strong anti-interference capability of the F-GO/GCE in the presence of other hydroxycinnamic acids and ascorbic acid. Moreover, the F-GO/GCE offered a good sensitivity, long-term stability, and an excellent reproducibility. The practical application of the electrochemical F-GO sensor was verified using various brands of commercially available wine. The developed electrochemical sensor successfully displayed its ability to directly detect CA in wine samples without pretreatment, making it a promising candidate for food and beverage quality control. Full article

The adhesin Legionella collagen-like (Lcl) protein can bind to extracellular matrix components and mediate the binding of Legionella pneumophila to host cells. In this study, electrochemical impedance spectroscopy (EIS) and surface plasmon resonance (SPR)-based biosensors were employed to characterize these interactions between glycosaminoglycans (GAGs) and the adhesin Lcl protein. Fucoidan displayed a high affinity (K_D 18 nM) for Lcl protein. Chondroitin sulfate A and dermatan sulfate differ in the position of a carboxyl group replacing D-glucuronate with D-iduronate. Our results indicated that the presence of D-iduronate in dermatan sulfate strongly hindered its interaction with Lcl. These biophysical studies provided valuable information in our understanding of adhesin-ligand interactions related to Legionella pneumophila infections. Full article

Graphene and its chemically exfoliated derivatives—GO and rGO—are the key members of graphene family materials (GFM). The atomically thick crystal structure and the large continuous π conjugate of graphene imparts it with unique electrical, mechanical, optical, thermal, and chemical properties. Although those properties of GO and rGO are compromised, they have better scalability and chemical tunability. All GFMs can be subject to noncovalent modification due to the large basal plane. Besides, they have satisfying biocompatibility. Thus, GFMs are promising materials for biological, chemical and mechanical sensors. The present review summarizes how to incorporate GFMs into different sensing system including fluorescence aptamer-based sensors, field-effect transistors (FET), and electrochemical sensors, as well as, how to covalently and/or non-covalently modify GFMs to achieve various detection purpose. Sensing mechanisms and fabrication strategies that will influence the sensitivity of different sensing system are also reviewed. Full article