Search Results (5)

Orbital radars are used to monitor the state of the sea ice in the Arctic and Antarctic. The backscattering radar cross section (RCS) is used to determine the type of scattering surface. The power of the reflected signal depends on many factors, so the problem of separating sea ice and sea waves is not always unambiguous. Previous research has shown that microwave Doppler radar installed on aircrafts can be used to determine the boundary of sea ice. The width of the Doppler spectrum for wide or knife-like antenna beam depends on the statistical parameters of the reflecting surface, so sea ice and sea waves are easily separated. However, when installing a Doppler radar on a satellite, the spatial resolution becomes extremely low. In this research, we discuss the possibility of improving the spatial resolution by dividing the antenna footprint into elementary scattering cells. To do this, it is proposed to use the original incoherent synthesis procedure, which allows one to determine the dependence of the RCS on the incidence angle for an elementary scattering cell. Numerical modeling was performed and processing of model data confirmed that sea ice and sea waves are separated. The coefficient of kurtosis was used as a criterion in the algorithm. In addition, for sea waves, it is possible to determine the mean square slopes (mss) of large-scale waves, compared to the electromagnetic wavelength of sea waves along the sounding direction. Full article

In the radar remote sensing of sea ice, the main informative parameter is the backscattering radar cross section (RCS), which does not always make it possible to unambiguously determine the kind of scattering surface (ice/sea waves) and therefore leads to errors in estimating the area of the ice cover. This paper provides a discussion of the possibility of using the Doppler spectrum of the reflected microwave signal to solve this problem. For the first time, a semi-empirical model of the Doppler spectrum of a radar microwave signal reflected by an ice cover was developed for a radar with a wide antenna beam mounted on a moving carrier at small incidence angles of electromagnetic waves (0°–19°). To describe the Doppler spectrum of the reflected microwave signal, the following parameters were used: shift and width of the Doppler spectrum, as well as skewness and kurtosis coefficients. Research was conducted on the influence of the main parameters of the measurement scheme (movement velocity, width of antenna beam, sounding direction, incidence angle) and the sea ice concentration (SIC) on the parameters of the Doppler spectrum. It was shown that, in order to determine the kind of scattering surface, it is necessary to use a wide or knife-like (by the incidence angle) antenna. Calculations confirmed the assumption that, when measured from a moving carrier, the Doppler spectrum is a reliable indicator of the transition from one kind of scattering surface to another. The advantage of using the coefficients of skewness and kurtosis in the analysis is that it is not necessary to keep the radar velocity unchanged during the measurement process. Full article

It is expected that the problem of the azimuth cutoff wavelength in single-satellite synthetic aperture radar (SAR) observations can be solved by means of the cooperative observation of networked SAR satellites. Multiview SAR wave synchronization data are required in the process. However, most of the current orbiting satellites are geosynchronous orbit satellites; the simultaneous observation by multiple SARs in the same sea area cannot be achieved, and multiview synchronization data cannot be obtained. Therefore, this paper studies the simulation of the multiview SAR wave synchronization data. Ocean wave spectra were simulated by using the Pierson Moskowitz (PM) spectrum. The Monte Carlo method was used to simulate two-dimensional (2D) ocean surfaces at different wind speeds. The two-scale electromagnetic scattering model was used to calculate the ocean surface backscattering coefficient, and the time-domain echo algorithm was used to generate echo signals. The echo signals were processed by the Range–Doppler (RD) imaging algorithm to obtain ocean SAR data. Based on the obtained single-SAR wave data, networked satellites consisting of three SARs were simulated, and the SAR wave data were synchronized. The results show that when SARs are used to observe the same sea area from different observation directions, the clarity of the wave fringes in the SAR images are different. For different azimuth angles, the degrees of azimuth cutoff are different. These results reflect the influences of different degrees of azimuth cutoff on SAR images. The simulated wave synchronization data can be used as the basic data source for subsequent azimuth cutoff wavelength compensation. Full article

Land-based, high-frequency (HF) surface wave radar has the unique capability of monitoring coastal surface parameters, such as current, waves, and wind, up to 200 km off the coast. The Doppler spectrum of the backscattered radar signal is characterized by two strong peaks that are caused by the Bragg-resonant scattering from the ocean surface. The wavelength of Bragg resonant waves is exactly half the radio wavelength (grazing incidence), and these waves are located at the higher frequency part of the wave spectral distribution. When HF radar operates at higher frequencies, the resonant waves are relatively shorter waves, which are more sensitive to a change in wind direction, and they rapidly respond to local wind excitation and a change in wind direction. When the radar operates at lower frequencies, the corresponding resonant waves are relatively longer and take longer time to respond to a change in wind direction due to the progress of wave growth from short waves to long waves. For the wind inversion from HF radar backscatter signals, the accuracy of wind measurement is also relevant to radar frequency. In this paper, a pattern-fitting method for extracting wind direction by estimating the wave spreading parameter is presented, and a comparison of the pattern-fitting method and a conventional method is given as well, which concludes that the pattern-fitting method presents better results than the conventional method. In order to analyze the wind direction inversion from radar backscatter signals under different wind conditions and at different radar frequencies, two radar experiments accomplished in Norway and Italy are introduced, and the results of wind direction inversion are presented. In the two experiments, the radar worked at 27.68 MHz and 12 MHz, respectively, and the wind conditions at the sea surface were quite different. In the experiment in Norway, 67.4% of the wind records were higher than 5 m/s, while, in the experiment in Italy, only 18.9% of the wind records were higher than 5 m/s. All these factors affect the accuracy of wind direction inversion. The paper analyzes the radar data and draws a conclusion on the influencing factor of wind direction inversion. Full article

The influence of a surface-active substance (SAS) film on the Doppler spectrum width at small incidence angles is theoretically investigated for the first time for microwave radars with narrow-beam and knife-beam antenna patterns. It is shown that the requirements specified for the antenna system depend on the radar motion velocity. A narrow-beam antenna pattern should be used to detect slicks by an immobile radar, whereas radar with a knife-beam antenna pattern is needed for diagnostics from a moving platform. The study has revealed that the slick contrast in the Doppler spectrum width increases as the radar wavelength diminishes, thus it is preferable to utilize wavelengths not larger than 2 cm for solving diagnostic problems. The contrast in the Doppler spectrum width is generally weaker than that in the radar backscattering cross section; however, spatial and temporal fluctuations of the Doppler spectrum width are much weaker than those of the reflected signal power. This enables one to consider the Doppler spectrum as a promising indicator of slicks on water surface. Full article