Next Article in Journal
Analyses of Electric Field-Induced Phase Transformation by Luminescence Study in Eu3+-doped (Na, K)0.5Bi0.5TiO3 Ceramics
Previous Article in Journal
Photocatalytic Degradation of Diclofenac Using Al2O3-Nd2O3 Binary Oxides Prepared by the Sol-Gel Method
 
 
Article
Peer-Review Record

Influence of High-Temperature Liquid on Phase Composition and Morphology of Carbothermal Reduction-Nitridation Products from Coal Gasification Slag

Materials 2020, 13(6), 1346; https://doi.org/10.3390/ma13061346
by Hudie Yuan, Hongfeng Yin *, Yun Tang, Hang Shuai, Yalou Xin and Xilou Pu
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Materials 2020, 13(6), 1346; https://doi.org/10.3390/ma13061346
Submission received: 24 February 2020 / Revised: 12 March 2020 / Accepted: 13 March 2020 / Published: 16 March 2020

Round 1

Reviewer 1 Report

The aim of this paper to assess the influence of high-temperature liquid on the synthesis of Ca-α-SiAlON, starting from three kind of gasification slags from different gasifiers.

As structures, some minor corrections are required,a sin the following :

1) Introduction: Could be slightly extended. Furthermore, especially on pag 2 some references can be applied on the sentences.

2) Results and discussion. Figure 2. XRD pattern need to be better explained, assessing all phases appeared and qualitatively discuss their ratio. EDS spectra of the elongated and spherical particles must be also added

3) Based on the discussed results, the reaction process need to be proposed, extending the comparison of the three gasification slugs based on it.

4) As possible, the conclusion, should have quantitative results.

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

 

Reviewer 2 Report

This is a nice work on understanding the effect of phase composition during the CRN process on the characteristics of the products is presented. The work appears technically sound, however it can be further improved if the following comments are addressed:

1)The authors have not provided any significant information about thermodynamics of the process. Some basic details should be provided.

2) They have mentioned several software packages such as Factsage, Findit and Mood but have not referenced them properly. Appropriate references should be added.

3) What is "rom" in section 2.2.1? This probably a type and should be corrected.

4) "X" should be subscript in FeSix in the text.

 

Author Response

Please see the attachment.

Author Response File: Author Response.pdf

Back to TopTop