Development and Experimental Verification of a High-Temperature and In-Plane Biaxial Testing Apparatus
Round 1
Reviewer 1 Report
Comments for author File: 
Comments.pdf
Author Response
Please see the attachment.
Author Response File: Author Response.pdf
Reviewer 2 Report
Dear Authors,
Comments are in the attached file.
Comments for author File: Comments.pdf
Author Response
Please see the attachment.
Author Response File: Author Response.pdf
Round 2
Reviewer 2 Report
Dear Authors,
First of all, thank you for carefully review the paper. However, some points need to be improved yet, as follow:
* As previously mentioned, the scientific written should be checked, because sentences like "We apply a fixed force..." (line 386) still in the text. Check all the text, please;
* Figure 23 should be mentioned and explained in the text. Figure 22 it is not mentioned in the text. The information that these figures brings were not properly discussed yet;
* Authors mentioned about some requirements that should be met and they make some calibration to verify some of them. However, it is not clear which requirements should be met (even though the equipment was self-developed), and if the obtained results from the calibration procedure it is good or not;
* The written of the paper need to be improved yet.
Again, thank you so much for your kind answer in each point of the first report.
Author Response
Please see the attachment.
Author Response File: Author Response.pdf
