Next Article in Journal
Characterization of Heat-Polymerized Monomer Formulations for Dental Infiltrated Ceramic Networks
Next Article in Special Issue
Digital Denture Fabrication: A Technical Note
Previous Article in Journal
Establishment of a Geographic Information System-Based Algorithm to Analyze Suitable Locations for Green Roofs and Roadside Trees
Previous Article in Special Issue
Restorative Space Analysis by Jaw Motion Tracking Using a Template in Completely Edentulous Patients
 
 
Technical Note
Peer-Review Record

Fabrication of Metal-Reinforced Complete Dentures Using the CAD-CAM Technique

Appl. Sci. 2021, 11(16), 7369; https://doi.org/10.3390/app11167369
by Xing-Yu Piao, June-Sung Shim and Ji-Man Park *
Reviewer 1:
Reviewer 2: Anonymous
Appl. Sci. 2021, 11(16), 7369; https://doi.org/10.3390/app11167369
Submission received: 5 July 2021 / Revised: 24 July 2021 / Accepted: 29 July 2021 / Published: 11 August 2021
(This article belongs to the Special Issue Application of CAD/CAM and 3D Printing Technologies in Dentistry II)

Round 1

Reviewer 1 Report

see attached report

Comments for author File: Comments.docx

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Reviewer 2 Report

  • abstract is longer than it needs to be
  • the introduction is not exactly explaining the plan
  • the picture formats are not constants
  • the spacing between the lines are not the same
  • the spacing is not the same between words like here in page 4, "Pour autopolymerizing resin"
  • it is hard to follow the material and design section
  • the formating is not scientific, the spacing between two sides of the page is different
  • the format of the references is not consistent

 

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Back to TopTop