ijerph-logo

Journal Browser

Journal Browser

New Technologies in Industrial Wastewater Treatment

A special issue of International Journal of Environmental Research and Public Health (ISSN 1660-4601). This special issue belongs to the section "Environmental Science and Engineering".

Deadline for manuscript submissions: closed (12 October 2023) | Viewed by 2134

Special Issue Editors


E-Mail Website
Guest Editor
Department of Environmental Engineering and Occupational Safety and Health, Faculty of Technical Sciences, University of Novi Sad, Trg Dositeja Obradovića 6, 21000 Novi Sad, Serbia
Interests: emerging micropollutants; green technologies; industrial wastewater; water monitoring; biosorption; low cost materials

E-Mail Website
Guest Editor
Department of Environmental Engineering and Occupational Safety and Health, Faculty of Technical Sciences, University of Novi Sad, Trg Dositeja Obradovića 6, 21000 Novi Sad, Serbia
Interests: emerging micropollutants; advanced oxidation processes; nanomaterials; industrial wastewater

Special Issue Information

Dear Colleagues,

The production of large volumes of industrial wastewater as a consequence of urbanization and inadequate technical management, imposes significant pressure on environmental water compartments. A diversity of distinct emerging pollutants with recalcitrant properties, such as plasticizers, microplastics (MPs), nanoplastics (NPs), pharmaceuticals and pesticides, have been generated in response to the industrial sector’s rapid development. Industries such as pharmaceuticals, plastics and textiles are significant sources of a wide range of organic contaminants. Traditional designs of conventional treatments have many bottlenecks and barriers, making them ineffective for the removal of the newly detected pollutants. Due to the complex characteristics of pollutants, the application of new and modern purification technologies is of fundamental importance. For the development and design of new industrial wastewater technologies on a worldwide scale, pilot studies at the laboratory level might provide an excellent starting point. To adhere to predetermined regulatory requirements, industrial wastewater streams must undergo adequate treatment.

Some of themes of this Special Issue are focused on:

  • The possible technological solutions for the treatment of wastewater from specific industrial sectors (pharmaceutical, plastic, metal etc.).
  • Development of the technological strategy of applying different treatments for a specific group of industrial pollutants (microplastics, nanoplastics, pharmaceuticals, pesticides, plasticizers etc.).
  • Research on new green technologies in which the generated wastewater can be a source of valuable biomaterials and green energy. The benefits of these technologies can be two-fold: financial gains (circular economy and Sustainable Development Goals (SDGs) approach) and the reduction of anthropogenic stress on the water environment.

Dr. Ivana Mihajlović
Dr. Mladenka Novaković
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. International Journal of Environmental Research and Public Health is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2500 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • industrial wastewater
  • emerging treatments
  • circular economy in industrial wastewater treatment plants
  • green technologies
  • byproduct valorization and recovery
  • pilot scale studies
  • recalcitrant pollutants
  • sustainable sludge management

Benefits of Publishing in a Special Issue

  • Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
  • Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
  • Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
  • External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
  • e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.

Further information on MDPI's Special Issue polices can be found here.

Published Papers (1 paper)

Order results
Result details
Select all
Export citation of selected articles as:

Research

17 pages, 5773 KiB  
Article
How Well Do Our Adsorbents Actually Perform?—The Case of Dimethoate Removal Using Viscose Fiber-Derived Carbons
by Vladan Anićijević, Tamara Tasić, Vedran Milanković, Stefan Breitenbach, Christoph Unterweger, Christian Fürst, Danica Bajuk-Bogdanović, Igor A. Pašti and Tamara Lazarević-Pašti
Int. J. Environ. Res. Public Health 2023, 20(5), 4553; https://doi.org/10.3390/ijerph20054553 - 3 Mar 2023
Cited by 9 | Viewed by 1575
Abstract
Growing pollution is making it necessary to find new strategies and materials for the removal of undesired compounds from the environment. Adsorption is still one of the simplest and most efficient routes for the remediation of air, soil, and water. However, the choice [...] Read more.
Growing pollution is making it necessary to find new strategies and materials for the removal of undesired compounds from the environment. Adsorption is still one of the simplest and most efficient routes for the remediation of air, soil, and water. However, the choice of adsorbent for a given application ultimately depends on its performance assessment results. Here, we show that the uptake of and capacity for dimethoate adsorption by different viscose-derived (activated) carbons strongly depend on the adsorbent dose applied in the adsorption measurements. The specific surface areas of the investigated materials varied across a wide range from 264 m2 g−1 to 2833 m2 g−1. For a dimethoate concentration of 5 × 10−4 mol L−1 and a high adsorbent dose of 10 mg mL−1, the adsorption capacities were all below 15 mg g−1. In the case of high-surface-area activated carbons, the uptakes were almost 100% under identical conditions. However, when the adsorbent dose was reduced to 0.01 mg mL−1, uptake was significantly reduced, but adsorption capacities as high as 1280 mg g−1 were obtained. Further, adsorption capacities were linked to adsorbents’ physical and chemical properties (specific surface area, pore size distribution, chemical composition), and thermodynamic parameters for the adsorption process were evaluated. Based on the Gibbs free energy of the adsorption process, it can be suggested that physisorption was operative for all studied adsorbents. Finally, we suggest that a proper comparison of different adsorbents requires standardization of the protocols used to evaluate pollutant uptakes and adsorption capacities. Full article
(This article belongs to the Special Issue New Technologies in Industrial Wastewater Treatment)
Show Figures

Graphical abstract

Back to TopTop