Materials and Modelling of Implantable Biomedical Devices
A special issue of Materials (ISSN 1996-1944). This special issue belongs to the section "Biomaterials".
Deadline for manuscript submissions: closed (20 March 2023) | Viewed by 4325
Special Issue Editors
Interests: biomechanics; biomaterials; biomaterial engineering; biomedical engineering; bioinspired engineering and biomimetic design; biomechanical engineering
Special Issue Information
Dear Colleagues,
The study and modeling of implantable devices imply more complex analysis considerations than others referring to other types of conventional engineering systems. In fact, placing an implant in contact with living tissue through an interface introduces some unpredictability in its biomechanical and biological behavior. Although there have been significant scientific advances in the study of implantable systems, several problems continue to be recorded, especially those related to fixation, which is important in load transfer mechanisms because they precede their early failure. Thus, the design, materials and new emerging technologies that can be applied in the development of implantable biosystems must be modeled and studied, aiming for better and more adequate surgical procedures. There is potential in the development of new concepts, including artificial intelligence, which will allow, in the near future, to have intelligent implantable systems.
As guest editors, we propose that you submit your research concerning the analysis of biomaterials and numerical and experimental modeling of implantable biomedical systems.
Dr. José António Simões
Dr. António Manuel Monteiro Ramos
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- biomechanics
- materials
- modelling
- biomedical devices
- implant/prosthesis
- finite element analysis
- experimental biomechanics
Benefits of Publishing in a Special Issue
- Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
- Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
- Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
- External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
- e-Book format: Special Issues with more than 10 articles can be published as dedicated e-books, ensuring wide and rapid dissemination.
Further information on MDPI's Special Issue polices can be found here.