The authors wish to make the following correction to the paper [1]. Due to identical data in Table 6 and Table 7, replace:
Table 7.
ANOVA results for ULSF for ABS BM FDM.
Table 7.
ANOVA results for ULSF for ABS BM FDM.
| Factor | Unit | Level 1 | Level 2 | Level 3 | F-Value | p-Value |
|---|---|---|---|---|---|---|
| PT | °C | 230 | 255 | 280 | 2.15 | 1.34 × 10−1 |
| RT | mm | 0.1 | 0.2 | 0.3 | 5.73 | 8.0 × 10−3 |
| DS | mm/s | 20 | 40 | 60 | 32.38 | 1.24 × 10−6 |
| AC | wt.% | 5 | 15 | 25 | 29.42 | 2.43 × 10−5 |
| NC | - | 2 | 12 | 22 | 15.64 | 1.46 × 10−5 |
with
Table 7.
ANOVA results for ULSF for ABS BM FDM.
Table 7.
ANOVA results for ULSF for ABS BM FDM.
| Factor | Unit | Level 1 | Level 2 | Level 3 | F-Value | p-Value |
|---|---|---|---|---|---|---|
| PT | °C | 230 | 255 | 280 | 1.28 | 2.97 × 10−1 |
| RT | mm | 0.1 | 0.2 | 0.3 | 5.65 | 1.0 × 10−2 |
| DS | mm/s | 20 | 40 | 60 | 14.09 | 1.78 × 10−6 |
| NC | - | 2 | 12 | 22 | 17.19 | 2.32 × 10−5 |
These changes have no material impact on the discussion and conclusions of the paper. The authors would like to apologize for any inconvenience caused to the readers by these changes.
Acknowledgments
Open Access Funding by the Graz University of Technology.
Conflicts of Interest
The authors declare no conflicts of interest.
References
- Falck, R.; dos Santos, J.F.; Amancio-Filho, S.T. Microstructure and Mechanical Performance of Additively Manufactured Aluminum 2024-T3/Acrylonitrile Butadiene Styrene Hybrid Joints Using an AddJoining Technique. Materials 2019, 12, 864. [Google Scholar] [CrossRef] [PubMed]
© 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).