Next Article in Journal
Detection and 3D Visualization of Deformations for High-Rise Buildings in Shenzhen, China from High-Resolution TerraSAR-X Datasets
Next Article in Special Issue
Prediction Methods and Experimental Techniques for Chatter Avoidance in Turning Systems: A Review
Previous Article in Journal
An Efficient Resource Allocation Algorithm for Device-To-Device Communications
Previous Article in Special Issue
Contrast Experiments in Dielectrophoresis Polishing (DEPP)/Chemical Mechanical Polishing (CMP) of Sapphire Substrate
 
 
Article
Peer-Review Record

Experimental and Numerical Study of Edge Defects When Turning 17vol.% SiCp/2009Al Composites

Appl. Sci. 2019, 9(18), 3817; https://doi.org/10.3390/app9183817
by Li Zhou 1, Junfeng Xiang 2,*, Jie Yi 3, Peng Gao 4 and Jiaqing Xie 5
Reviewer 1: Anonymous
Reviewer 2: Anonymous
Appl. Sci. 2019, 9(18), 3817; https://doi.org/10.3390/app9183817
Submission received: 6 August 2019 / Revised: 5 September 2019 / Accepted: 9 September 2019 / Published: 11 September 2019

Round 1

Reviewer 1 Report

This paper indicates the edge defect in oblige turning process. These are my comments to improve the quality of paper.

1- The novelty of paper is not well address.

2- Fracture criteria used for FE simulation is not clearly stated. Why do you use this fracture criterion?

3- However the extensive experiment are done in this manuscript, the authors did not addressed the difference of FE and experimental in a scientific way.

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Reviewer 2 Report

See the file attached

Comments for author File: Comments.docx

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Round 2

Reviewer 1 Report

The paper can publish now in the present format as the authors address all comments. 

Reviewer 2 Report

The author made some important corrections.

Back to TopTop