Advances in Plastic Deformation Analysis and Process Design
A special issue of Applied Sciences (ISSN 2076-3417). This special issue belongs to the section "Mechanical Engineering".
Deadline for manuscript submissions: closed (28 February 2022) | Viewed by 1857
Special Issue Editor
Interests: rolling; ductile fracture
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Plastic deformation is one of the processing fields that rapidly developed to solve the productivity problem of cutting processing after World War II. Since the 1980s, the finite element (FE) analysis capability of plastic deformation has improved fast, and as a result, many papers on FE analysis of plastic deformation have been published. In the 1990s, precise computer models predicting plastic deformation behavior began to be developed, and FE analysis results applicable to the actual production site began to appear in the literature. Recently, advanced plastic deformation analysis techniques that combine mechanics and metallurgy are emerging, and attempts are being made to apply the results to improve product quality and create new products. Hence, in this Special Issue on “Advances in Plastic Deformation Analysis and Process Design”, we would like to recruit mechanistic-based or metallurgical-based papers or papers that combine the two fields. In particular, papers that contribute to innovation in plastic processing design by incorporating AI are welcomed.
Prof. Dr. Youngseog Lee
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Applied Sciences is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2400 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- new constitutive models
- new technologies of process design in metal forming
- damage evolution during plastic deformation
- texture evolution during cold deformation
- recrystallization and phase transformation during hot deformation
- AI-based method to improve plastic product defects and productivity
