Research on Enhancing Properties of Aluminum-Based Materials
A special issue of Materials (ISSN 1996-1944). This special issue belongs to the section "Metals and Alloys".
Deadline for manuscript submissions: 20 September 2024 | Viewed by 1692
Special Issue Editors
Interests: aluminum matrix composite; microstructure characterization; microstructure and properties; light alloys; strengthening and toughening mechanism; functionally gradient materials
Interests: aluminum matrix composite; dynamic mechanical behavior; biomimetic materials; strengthening and toughening mechanism; ballistic performance; light alloys
Special Issue Information
Dear Colleagues,
The aluminum matrix composites (AMCs) have raised an enormous concern during the past several decades due to the corresponding high specific strength, high specific modulus, excellent dimensional stability, good wear resistance, etc. AMCs have broad application prospects in aerospace, electronic packaging, automobile, armor protection and other fields. How to improve the mechanical and functional properties of aluminum matrix composites through material design, microstructure control, and high-quality preparation is a crucial issue. For this reason, the present Special Issue “Research on Enhancing Properties of Aluminum-Based Materials” is proposed. This Special Issue aims to collect excellent studies on aluminum matrix composites from around the world, including but not limited to the preparation process, heat treatment, microstructure control and design, mechanical performance, microstructure characterization, electrical conductivity, thermal conductivity, ballistic performance, precipitate phase, interfaces, TEM, SEM, XRD and EBSD.
Prof. Dr. Longtao Jiang
Guest Editor
Dr. Zhenlong Chao
Guest Editor Assistant
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- aluminum matrix composites
- preparation process
- heat treatment
- microstructure control and design
- mechanical performance
- electrical conductivity
- thermal conductivity
- precipitate phase
- microstructure characterization
- strengthening and toughening mechanism