Additive Manufacturing: Technology, Challenges and Applications
A special issue of Micromachines (ISSN 2072-666X). This special issue belongs to the section "D3: 3D Printing and Additive Manufacturing".
Deadline for manuscript submissions: closed (25 November 2022) | Viewed by 4443
Special Issue Editor
Interests: additive printing; injection; polymer and polymer composites; material characterization; FEM simulation
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
This Special Issue focuses on recent advances in additive manufacturing processes, applications and technologies. There is a growing need to know determine the new industrial applications of AM, and identify the new materials that are being applied in the field. It is necessary to discover what the future trends of new technologies are. Each technology and each application sector present needs that must be considered, from the part’s design, to the processing conditions of the same. Original research papers and review articles are invited for this Special Issue.
Dr. Santiago Ferrandiz
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Micromachines is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- additive manufacturing
- AM trends
- AM design
- DFAM