Search Results (47)

Optical biosensors play a crucial role in the field of biological detection by converting biological signals into optical signals for detection. Among them, Surface Plasmon Resonance (SPR) optical biosensors have become a research hotspot in this field due to their significant advantage of high sensitivity. Weyl Semimetals (WSMs), as a type of three-dimensional topological material with unique electronic structures and other properties, exhibit potential applications in the field of SPR sensing. Against this background, we designed a terahertz (THz) high-sensitivity SPR phase biosensor with a KR structure based on WSMs. When applied in gas sensing scenarios, the phase detection sensitivity of this sensor can reach 22,402$°$/RIU, showing a significant improvement compared to traditional SPR biosensors. Moreover, we found that the Weyl node separation distance and twist angle of WSMs have obvious effects on sensitivity regulation. Additionally, we optimized the sensitivity and structural parameters of this structure using a neural network-based deep learning algorithm. We expect that this proposed scheme can provide a feasible reference for the field of biological sensing. Full article

A novel terahertz-responsive chip was developed for rapid, non-contact detection of nickel metal particle concentrations in aqueous solutions. The chip integrates a Weyl semimetal thin film as the active layer and a sub-wavelength metallic structure as the substrate. Upon terahertz wave irradiation, distinct responses were observed in liquids containing varying nickel concentrations, enabling the establishment of a robust correlation between concentration and terahertz signal. Experimental results demonstrate the chip’s capability to quantify nickel particles (10–30 μm), with a detection limit below 0.01 mg/L and a relative standard deviation of <3% across repeatability tests. This technology offers a high-speed, precise, and low-limit solution for water quality monitoring, with significant potential for environmental applications. Full article

Topological photonic sensors have emerged as a breakthrough in modern optical sensing by integrating topological protection and light confinement mechanisms such as topological states, quasi-bound states in the continuum (quasi-BICs), and Tamm plasmon polaritons (TPPs). These devices exhibit exceptional sensitivity and high-Q resonances, making them ideal for high-precision environmental monitoring, biomedical diagnostics, and industrial sensing applications. This review explores the foundational physics and diverse sensor architectures, from refractive index sensors and biosensors to gas and thermal sensors, emphasizing their working principles and performance metrics. We further examine the challenges of achieving ultrahigh-Q operation in practical devices, limitations in multiparameter sensing, and design complexity. We propose physics-driven solutions to overcome these barriers, such as integrating Weyl semimetals, graphene-based heterostructures, and non-Hermitian photonic systems. This comparative study highlights the transformative impact of topological photonic sensors in achieving ultra-sensitive detection across multiple fields. Full article

NbAs is a Weyl semimetal and belongs to the group of topological phases that exhibit distinct quantum and topological attributes. Topological phases have a fundamentally different response to external perturbations, such as magnetic fields. To obtain insights into the response of such phases to pressure, we conducted a comprehensive study on the pressure-induced electronic and structural transitions in NbAs. We used micro-X-ray diffraction (XRD) and micro-X-ray spectroscopy (XAS) techniques to elucidate the changes at different atomic and electronic length scales (local, medium, and bulk) as combined with theoretical calculations. High-pressure XRD measurements revealed a rather common compression behavior up to ~12 GPa that could be fitted to an equation of state formalism with a bulk modulus of $⟨K_0⟩=$ 179.6 GPa. Complementary Nb K-edge XAS data unveiled anomalies at pressure intervals of ~12–15 and ~25–26 GPa in agreement with previous literature data from XRD studies. We attribute these anomalies to a previously reported topological Lifshitz transition and the tetragonal-to-hexagonal phase transition, respectively. Analysis of EXAFS results revealed slight changes in the mean next-nearest neighbor distance Nb–As₍₁₎ (~2.6 Å) at ~15 GPa, while the second nearest neighboring bond Nb–Nb₍₁₎ (~3.4 Å) shows a pronounced anomaly. This indicates that the electronic changes across the Lifshitz transition are accommodated first in the medium-range atomic structure and then at the local range and bulk. The variances of these bonds show anomalous but progressive evolutions close to the tetragonal-to-hexagonal transition at ~25 GPa, which allowed us to derive the evolution of vibration properties in this material. We suggest a prominent displacive character of the $I{4}_{1}md\to P\overline{6}m2$ transition facilitated by phonon modes. Full article

The charge properties and regularities of mutual influence of the electro-physical parameters in a metal (M)/insulator (I)/two-dimensional crystal heterostructure were studied. In one case, the transition metal dichalcogenide (TMD) MoS₂ was considered as a two-dimensional crystal, and in another the Weyl semi-metal (WSM) ZrTe₅, representative of a quasi-two-dimensional crystal was chosen for this purpose. By self-consistently solving the electrostatic equations of the heterostructures under consideration and the Fermi–Dirac distribution, the relationship between such parameters as the concentration of charge carriers, chemical potential, and quantum capacitance of the TMD (WSM), as well as the capacitance of the I layer and the interface capacitance I–TMD (WSM), and their dependence on the field electrode potential, have been derived. The conditions for the emergence of charge instability and the critical phenomena caused by it are also determined. Full article

Topological Weyl semimetals are characterized by open Fermi arcs on their terminal surfaces, these materials not only changed accepted concepts of the Fermi loop but also enabled many exotic phenomena, such as one-way propagation. The key prerequisite is that the two terminal surfaces have to be well separated, i.e., the Fermi arcs are not allowed to couple with each other. Thus, their interaction was overlooked before. Here, we consider coupled Fermi arcs and propose a Weyl planar waveguide, wherein we found a saddle-chips-like hybridized guiding mode. The hybridized modes consist of three components: surface waves from the top and bottom surfaces and bulk modes inside the Weyl semimetal. The contribution of these three components to the hybridized mode appears to be z-position-dependent rather than uniform. Beyond the conventional waveguide framework, those non-trivial surface states, with their arc-type band structures, exhibit strong selectivity in propagation direction, providing an excellent platform for waveguides. Compared with the conventional waveguide, the propagation direction of hybridized modes exhibits high z-position-dependency. For example, when the probe plane shifts from the top interface to the bottom interface, the component propagating horizontally becomes dimmer, while the component propagating vertically becomes brighter. Experimentally, we drilled periodic holes in metal plates to sandwich an ideal Weyl meta-crystal and characterize the topological guiding mode. Our study shows the intriguing behaviors of topological photonic waveguides, which could lead to beam manipulation, position sensing, and even 3D information processing on photonic chip. The Weyl waveguide also provides a platform for studying the coupling and the interaction between surface and bulk states. Full article

One manifestation of light-Weyl fermion interaction is the emergence of chiral magnetic effects under magnetic fields. Probing real space magnetic responses at terahertz (THz) scales is challenging but highly desired, as the local responses are less affected by the topologically trivial inhomogeneity that is ubiquitous in spatially averaged measurements. Here, we implement a cryogenic THz microscopy instrument under a magnetic field environment—a task only recently achieved. We explore the technical approach of this system and characterize the magnetic field’s influence on our AFM operation by statistical noise analysis. We find evidence for local near-field spatial variations in the topological semimetal ZrTe₅ up to a 5-Tesla magnetic field and obtain near-field THz spectra to discuss their implications for future studies on the chiral magnetic effect. Full article

The quantitative description of electrical and magnetotransport properties of solid-state materials has been a remarkable challenge in materials science over recent decades. Recently, the discovery of a novel class of materials—the topological semimetals—has led to a growing interest in the full understanding of their magnetotransport properties. In this review, the strong interplay among topology, band structure, and carrier mobility in recently discovered high carrier mobility topological semimetals is discussed and their effect on their magnetotransport properties is outlined. Their large magnetoresistance effect, especially in the Hall transverse configuration, and a new version of a three-dimensional quantum Hall effect observed in high-mobility Weyl and Dirac semimetals are reviewed. The possibility of designing novel quantum sensors and devices based on solid-state semimetals is also examined. Full article

This review presents the recent advances in the search for thermoelectric (TE) materials, mostly among intermetallic compounds and in the enhancement of their TE performance. Herein, contemporary approaches towards improving the efficiency of heat–electricity conversion (e.g., energy harvesting and heat pumping) are discussed through the understanding of various emergent physical mechanisms. The strategies for decoupling the individual TE parameters, as well as the simultaneous enhancement of the TE power factor and the suppression of heat conduction, are described for nanoparticle-doped materials, high entropy alloys, and nanowires. The achievement of a superior TE performance due to emergent quantum phenomena is discussed for intermetallic chalcogenides and related systems (e.g., strong and weak topological insulators, Weyl and Dirac semimetals), and some of the most promising compounds within these classes are highlighted. It was concluded that high-entropy alloying provides a methodological breakthrough for employing band engineering methods along with various phonon scattering mechanisms towards significant TE efficiency improvement in conventional TE materials. Finally, topological semimetals and magnetic semimetals with several intriguing features, such as a violation of the Wiedemann–Franz law and outstanding perpendicular Nernst signals, are presented as strong candidates for becoming next-generation TE quantum materials. Full article

The YbCoC₂ compound, which crystallizes in a base-centered orthorhombic unit cell in the $Amm2$ space group CeNiC₂ structure, is unique among Yb-based compounds due to the highest magnetic ordering temperature of $T_N=27$ K. Magnetization measurements have made it possible to plot the H-T magnetic phase diagram and determine the magnetocaloric effect of this recently discovered high-temperature heavy-fermion compound, YbCoC₂. YbCoC₂ undergoes spin transformation to the spin-polarized state through a metamagnetic transition in an external magnetic field. The transition is found to be of the first order. The dependencies of magnetic entropy change $\Delta S_m\left(T\right)$—have segments with positive and negative magnetocaloric effects for $\Delta H\le 6$ T. For $\Delta H=9$ T, the magnetocaloric effect becomes positive, with a maximum $\Delta S_m\left(T\right)$ value of 4.1 J (kg K)⁻¹ at $T_N$ and a refrigerant capacity value of 56.6 J kg⁻¹. Full article

The positron annihilation lifetimes were measured using a ${}^{48}$V positron source in noncentrosymmetric cubic single crystals of CoSi, FeSi and MnSi. The following lifetimes were determined from the positron annihilation time spectra: 168(1) ps for CoSi, 114(1) ps for FeSi and 111(1) ps for MnSi. For single-crystal CoSi, the positron annihilation lifetime was also determined with a ${}^{22}$Na positron source. For CoSi, the lifetimes obtained from different positron sources are consistent. The differences in the positron annihilation lifetimes in MnSi and FeSi, on the one hand, and in the Weyl semimetal CoSi, on the other hand, are possibly caused by the formation of a positron + electron bound state (positronium). Full article

The size of transistors has drastically reduced over the years. Interconnects have likewise also been scaled down. Today, conventional copper (Cu)-based interconnects face a significant impediment to further scaling since their electrical conductivity decreases at smaller dimensions, which also worsens the signal delay and energy consumption. As a result, alternative scalable materials such as semi-metals and 2D materials were being investigated as potential Cu replacements. In this paper, we experimentally showed that CoPt can provide better resistivity than Cu at thin dimensions and proposed hybrid poly-Si with a CoPt coating for local routing in standard cells for compactness. We evaluated the performance gain for DRAM/eDRAM, and area vs. performance trade-off for D-Flip-Flop (DFF) using hybrid poly-Si with a thin film of CoPt. We gained up to a 3-fold reduction in delay and a 15.6% reduction in cell area with the proposed hybrid interconnect. We also studied the system-level interconnect design using NbAs, a topological semi-metal with high electron mobility at the nanoscale, and demonstrated its advantages over Cu in terms of resistivity, propagation delay, and slew rate. Our simulations revealed that NbAs could reduce the propagation delay by up to 35.88%. We further evaluated the potential system-level performance gain for NbAs-based interconnects in cache memories and observed an instructions per cycle (IPC) improvement of up to 23.8%. Full article

The non-trivial topology of electronic bands in Weyl semimetals originates from band inversion due to strong spin–orbit coupling. The Weyl semimetals have pairs of Weyl gap-less nodes in the bulk Brillouin zone. The tungsten ditelluride WTe₂ likely belongs to type II Weyl semimetals. Doping WTe₂ with magnetic ions could induce magnetic ordering in this crystal, which provides prospects for practical applications. We studied the magnetic properties of the iron-doped single crystals Fe_0.03W_0.97Te₂, annealed and unannealed, in comparison with the undoped WTe₂. Measurements of the dc magnetization were carried out from 1.8 to 400 K. We revealed pronounced ferromagnetic ordering that was affected by annealing. Anomalies associated with antiferromagnetism and paramagnetism were also found. The magnetic order was suppressed by a field of 60 kOe. The rise in susceptibility with increasing temperature was observed at high temperatures in all samples and was treated using a model developed for Weyl semimetals. The Curie–Weiss law fit at 60 kOe showed that the effective magnetic moment was close to that of Fe²⁺. Metamagnetism was demonstrated for the unannealed doped WTe₂ crystal. The data for the heat capacity of the iron-doped sample agreed with results for the undoped WTe₂. Full article

In this study, we report the successful growth of single crystals of a magnetic Weyl semimetal candidate NdAlGe with the space group I4₁md. The crystals were grown using a floating-zone technique, which used five laser diodes, with a total power of 2 kW, as the heat source. To ensure that the molten zone was stably formed during the growth, we employed a bell-shaped distribution profile of the vertical irradiation intensity. After the nominal powder, crushed from an arc-melted ingot, was shaped under hydrostatic pressure, we sintered the feed and seed rods in an Ar atmosphere under ultra-low oxygen partial pressure (<10⁻²⁶ atm) generated by an oxygen pump made of yttria-stabilized zirconia heated at 873 K. Single crystals of NdAlGe were successfully grown to a length of 50 mm. The grown crystals showed magnetic order in bulk at 13.5 K. The fundamental physical properties were characterized by magnetic susceptibility, magnetization, specific heat, thermal expansion, and electrical resistivity measurements. This study demonstrates that the magnetic order induces anisotropic magnetoelasticity, magneto-entropy, and charge transport in NdAlGe. Full article