Submit to Special Issue Submit Abstract to Special Issue Review for Energies Propose a Special Issue

Journal Browser

Modeling, Simulation and Optimization of Power System

Print Special Issue Flyer
Special Issue Editors
Special Issue Information
Keywords
Published Papers

A special issue of Energies (ISSN 1996-1073). This special issue belongs to the section "F1: Electrical Power System".

Deadline for manuscript submissions: 30 September 2024 | Viewed by 5259

Share This Special Issue

Special Issue Editors

Dr. Lin Zhu

E-Mail Website
Guest Editor

School of Electric Power Engineering, South China University of Technology, Guangzhou 510640, China
Interests: power system stability and control; power system modeling and simulation; DC /FACTS technology; new energy generation and grid connection

Dr. Zhigang Wu

E-Mail Website
Guest Editor

School of Electric Power Engineering, South China University of Technology, Guangzhou 510640, China
Interests: power system modeling; numerical simulation technology and applications of complex network theory in power systems

Special Issue Information

Dear Colleagues,

Power systems are complex and interconnected networks that facilitate the generation, transmission, and distribution of electrical energy. Modeling, simulation, and optimization are crucial tools for understanding and managing the complex behavior of power systems, as well as for designing more efficient and reliable power systems.

This Special Issue seeks to bring together researchers and practitioners from academia to present the latest advances in the modeling, simulation, and optimization of power systems.

We invite original research papers, review articles, and case studies on topics that include, but are not limited to:

Power system modeling and simulation techniques.
Optimization methods for power system planning and operation.
Energy management systems and smart grid technologies.
Power system stability and control.
Power system protection and reliability.
Power electronics and renewable energy integration.
Power system dynamics and transient analysis.
Demand response and energy storage systems.
Cybersecurity in power systems.
Economic analysis of power system planning and operation.

Dr. Lin Zhu
Dr. Zhigang Wu
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Energies is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

power system transient stability
model reduction
real-time simulator
nonlinear modeling
parameter identification
dynamic equivalent
data-driven

Published Papers (7 papers)

Download All Papers

Research

25 pages, 9713 KiB

Open AccessArticle

Ground Fault in Medium-Voltage Power Networks with an Isolated Neutral Point: Spectral and Wavelet Analysis of Selected Cases in an Example Industrial Network Modeled in the ATP-EMTP Package

by Krzysztof Kuliński and Adam Heyduk

Energies 2024, 17(7), 1532; https://doi.org/10.3390/en17071532 - 22 Mar 2024

Viewed by 505

Abstract

The paper presents some case spectral analysis of zero-sequence voltages and currents in an example industrial power distribution network. The network layout is based on typical power delivery networks in underground coal mines. Ground fault simulations have been made using an ATP/EMTP program. Due to the high environmental risks, the reliability of the protection relay operation related to their selectivity plays an important role. This paper tries to find the reasons for nonselective operation and unnecessary tripping in extensive mine cable networks, particularly with large power sources of higher-order harmonics. It was found that in transient states—due to the decaying oscillations occurring in complex RLC circuits—the results of short time measurements of the criterion values for ground fault protective relays can be overestimated (particularly for small values of ground resistance) and lead to nonselective tripping of a healthy cable line. Therefore, it might be advisable to increase the integration time used for measuring rms values. Also, if there is a significant level of higher harmonics in the industrial network generated by high-power converters, it should be noted that the higher harmonics of the ground fault current and currents measured by ground fault protection relays assume much higher values, which may also cause nonselective tripping. In this case, it may be advisable to use higher harmonic filters in the measuring circuits and to select a sufficiently high sampling frequency in the digital protective relays. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

19 pages, 2945 KiB

Open AccessArticle

Optimization of Ampacity in High-Voltage Underground Cables with Thermal Backfill Using Dynamic PSO and Adaptive Strategies

by Brayan A. Atoccsa, David W. Puma, Daygord Mendoza, Estefany Urday, Cristhian Ronceros and Modesto T. Palma

Energies 2024, 17(5), 1023; https://doi.org/10.3390/en17051023 - 22 Feb 2024

Viewed by 873

Abstract

This article addresses challenges in the design of underground high-voltage transmission lines, focusing on thermal management and cable ampacity determination. It introduces an innovative proposal that adjusts the dimensions of the backfill to enhance ampacity, contrasting with the conventional approach of increasing the core cable’s cross-sectional area. The methodology employs a particle swarm optimization (PSO) technique with adaptive penalization and restart strategies, implemented in MATLAB for parameter autoadaptation. The article emphasizes more efficient solutions than traditional PSO, showcasing improved convergence and precise results (success probability of 66.1%). While traditional PSO is 81% faster, the proposed PSO stands out for its accuracy. The inclusion of thermal backfill results in an 18.45% increase in cable ampacity, considering variations in soil thermal resistivity, backfill properties, and ambient temperature. Additionally, a sensitivity analysis was conducted, revealing conservative values that support the proposal’s robustness. This approach emerges as a crucial tool for underground installation, contributing to continuous ampacity improvement and highlighting its impact on decision making in energy systems. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

19 pages, 4628 KiB

Open AccessArticle

Evaluation of FACTS Contributions Using Branch Flow Model and Newton–Raphson Algorithm

by Marco Junior Ticllacuri Corpus and Jonatas B. Leite

Energies 2024, 17(4), 918; https://doi.org/10.3390/en17040918 - 16 Feb 2024

Viewed by 353

Abstract

Flexible alternating current transmission systems (FACTSs) have been widely incorporated in electric power systems in order to control system parameters. This paper proposes the modeling of four FACTS devices, using the Branch Flow Model (BF) as an optimization problem to reduce the complexity of the Newton–Raphson (NR) load flow code with FACTS devices. The devices are represented as variable impedances, as a function of a firing angle, and as voltage source converters (VSCs) located on the buses and transmission lines. This proposed model solves the problem associated with the selection of appropriate initial conditions of the parameters of each device that guarantee convergence. The model is validated by evaluating its percentage deviation with respect to the NR method, using the standard test systems, IEEE 5-bus, IEEE 14-bus, IEEE 30-bus, and IEEE 57-bus systems. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

21 pages, 4437 KiB

Open AccessArticle

A Dynamic Nonlinear VDCOL Control Strategy Based on the Taylor Expansion of DC Voltages for Suppressing the Subsequent Commutation Failure in HVDC Transmission

by Hongzheng Li, Kunlun Han, Shuhao Liu, Hailin Chen, Xiongfeng Zhang and Kangtai Zou

Energies 2023, 16(21), 7342; https://doi.org/10.3390/en16217342 - 30 Oct 2023

Viewed by 798

Abstract

Subsequent commutation failure in high-voltage DC transmission systems seriously emphasizes the safe and stable operation of power systems. Via analyzing the mechanism of commutation failure and the principle of voltage-dependent current order limiter (VDCOL), this paper proposes a dynamic nonlinear VDCOL control strategy based on the Taylor expansion of DC voltage for suppressing subsequent commutation failure. To solve the problem of fluctuating DC current command value caused by a large drop in DC voltage, this paper constructs a nonlinear VDCOL control that can be dynamically adjusted according to the AC bus voltage level, and Taylor expansion of DC voltage is used to obtain its first-order and second-order differential components. Different scales of differential elements are chosen to predict the DC voltage compensation value while balancing sensitivity and accuracy. The compensated DC voltage, used as the starting voltage of VDCOL, is input to the VDCOL control constructed in this paper to suppress the subsequent commutation failure of the transmission system by reducing the fluctuation of the current command value. Finally, the standard test model of HVDC is established based on the actual parameters, and the simulation results show that the Method proposed in this paper has an effective suppressing effect in the case of single-phase or three-phase faults of different severity and is conducive to the restoration of the system power transmission. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

21 pages, 4373 KiB

Open AccessEditor’s ChoiceArticle

A Two-Terminal Directional Protection Method for HVDC Transmission Lines of Current Fault Component Based on Improved VMD-Hilbert Transform

by Shuhao Liu, Kunlun Han, Hongzheng Li, Tengyue Zhang and Fengyuan Chen

Energies 2023, 16(19), 6987; https://doi.org/10.3390/en16196987 - 07 Oct 2023

Cited by 1 | Viewed by 741

Abstract

The traveling wave protection of high voltage direct current (HVDC) transmission lines is susceptible to the influence of transition resistance. As a backup protection, current differential protection has absolute selectivity, but usually requires an increase in delay to avoid misoperation caused by distributed capacitance on the line, resulting in a longer action time. Based on this, a two-terminal directional protection method for HVDC transmission lines is proposed based on Sparrow Search Algorithm (SSA)-Variational Mode Decomposition (VMD) and Hilbert phase difference. On the basis of analyzing the directional characteristics of the current fault component at both ends of the rectifier and inverter sides under different faults, SSA is first used to optimize the parameters of VMD. The residual components representing the direction of the current fault component at both ends are extracted through VMD, and then the Hilbert phase difference of the residual components at both ends is calculated to identify faults inside and outside the line area. In addition, fault pole selection can be achieved based on the ratio of the sum of multi-band Hilbert energy of single-terminal voltage fault components at the positive and negative poles. Simulation experiments have shown that the proposed protection scheme can quickly and effectively identify fault and has good tolerance to transition resistance and noise interference. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

20 pages, 6042 KiB

Open AccessArticle

Dynamic Equivalent Modeling of a Large Renewable Power Plant Using a Data-Driven Degree of Similarity Method

by Mengjun Liao, Lin Zhu, Yonghao Hu, Yang Liu, Yue Wu and Leke Chen

Energies 2023, 16(19), 6934; https://doi.org/10.3390/en16196934 - 03 Oct 2023

Viewed by 747

Abstract

This paper aims to develop a novel method for the dynamic equivalence of a renewable power plant, ultimately contributing to power system modeling and enhancing the integration of renewable energy sources. In order to address the challenge posed by clusters of renewable generation units during the equivalence process, the paper introduces the degree of similarity to assess similarity features under data. After leveraging the degree of similarity in conjunction with data-driven techniques, the proposed method efficiently entails dividing numerous units in a large-scale plant into distinct clusters. Additionally, the paper adopts practical algorithms to determine the parameters for each aggregated cluster and streamline the intricate collector network within the renewable power plant. The equivalent model of a renewable power plant is thereby conclusively derived. Comprehensive case studies are conducted within a practical offshore wind plant setting. These case studies are accompanied by simulations, highlighting the advantages and effectiveness of the proposed method, offering an accurate representation of the renewable power plant under diverse operating conditions. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

21 pages, 2301 KiB

Open AccessArticle

A Collaborative Planning Method for the Source and Grid in a Distribution System That Considers Risk Measurement

by Jiahao Deng, Lingxue Lin, Yongjie Zhang and Yuxin Ma

Energies 2023, 16(15), 5648; https://doi.org/10.3390/en16155648 - 27 Jul 2023

Viewed by 603

Abstract

The existing distribution system planning methods do not fully consider improving power supply capacity and reliability through the coordination of multiple planning factors, and they are not comprehensive enough in quantifying planning risks. Therefore, this paper proposes a collaborative planning method for sources and networks that considers risk measurement. A multi-layer planning model is first constructed that includes a grid planning layer, a power planning layer, a switch planning layer, and an operation optimization layer. In the model, a risk measurement method combining opportunity constraints and conditional value-at-risk objectives is used to comprehensively assess the risk of the node voltage and branch current exceeding the limit caused by load uncertainty. Then, a solution strategy based on a genetic algorithm and a sparrow search algorithm is proposed to coordinate the contradiction between the solution time and the accuracy of the multi-layer model. Finally, taking a planned area to be expanded as an example, the results show that compared to the existing collaborative planning methods for sources and networks, the proposed method in this paper reduces the planning risks caused by load uncertainty by more than 50% and increases the annual net income of the power distribution company and the DG operators by RMB 1.5 million and RMB 1.1 million, respectively. Full article

(This article belongs to the Special Issue Modeling, Simulation and Optimization of Power System)

► Show Figures

Figure 1

Journal Menu

Journal Browser

Modeling, Simulation and Optimization of Power System

Share This Special Issue

Special Issue Editors

Special Issue Information

Keywords

Published Papers (7 papers)

Research

Further Information

Guidelines

MDPI Initiatives

Follow MDPI