Next Issue
Volume 4, March
Previous Issue
Volume 3, September
 
 

Actuators, Volume 3, Issue 4 (December 2014) – 1 article , Pages 285-292

  • Issues are regarded as officially published after their release is announced to the table of contents alert mailing list.
  • You may sign up for e-mail alerts to receive table of contents of newly released issues.
  • PDF is the official format for papers published in both, html and pdf forms. To view the papers in pdf format, click on the "PDF Full-text" link, and use the free Adobe Reader to open them.
Order results
Result details
Section
Select all
Export citation of selected articles as:
424 KiB  
Communication
Development of a Paper Actuator with PEDOT:PSS Thin-Films as An Electrode
by Yusuke Hara and Yoshinori Yamaguchi
Actuators 2014, 3(4), 285-292; https://doi.org/10.3390/act3040285 - 09 Dec 2014
Cited by 6 | Viewed by 9204
Abstract
A paper actuator was fabricated from poly(3,4-ethylenedioxythiophene) doped with poly(4-styrenesulfonate) (PEDOT:PSS) by a wet process without organic solvents. The paper actuator had a capacitor structure, with a cationic polymer as an insulating layer sandwiched between two PEDOT:PSS films as the electrodes. The thickness [...] Read more.
A paper actuator was fabricated from poly(3,4-ethylenedioxythiophene) doped with poly(4-styrenesulfonate) (PEDOT:PSS) by a wet process without organic solvents. The paper actuator had a capacitor structure, with a cationic polymer as an insulating layer sandwiched between two PEDOT:PSS films as the electrodes. The thickness of the paper actuator was approximately 36 mm. We measured its displacement as a function of applied voltage and frequency; the maximum displacement was 2.2 mm at 1.5 V and 1 Hz. Full article
Show Figures

Figure 1

Previous Issue
Next Issue
Back to TopTop