Next Article in Journal
Riceberry Rice Germination and UVB Radiation Enhance Protocatechuic Acid and Vanillic Acid to Reduce Cellular Oxidative Stress and Suppress B16F10 Melanogenesis Relating to F-Actin Rearrangement
Next Article in Special Issue
Disentangling the Heterosis in Biomass Production and Radiation Use Efficiency in Maize: A Phytomer-Based 3D Modelling Approach
Previous Article in Journal
Metabolite Profiling and Bioactivities of Leaves, Stems, and Flowers of Rumex usambarensis (Dammer) Dammer, a Traditional African Medicinal Plant
Previous Article in Special Issue
Geometric Wheat Modeling and Quantitative Plant Architecture Analysis Using Three-Dimensional Phytomers
 
 
Article
Peer-Review Record

Design and Development of a Low-Cost UGV 3D Phenotyping Platform with Integrated LiDAR and Electric Slide Rail

by Shuangze Cai 1,2, Wenbo Gou 2, Weiliang Wen 2,3, Xianju Lu 2, Jiangchuan Fan 2,4,* and Xinyu Guo 1,2,3,*
Reviewer 1: Anonymous
Reviewer 2:
Submission received: 9 December 2022 / Revised: 12 January 2023 / Accepted: 18 January 2023 / Published: 20 January 2023
(This article belongs to the Special Issue 3D Imaging Techniques Adapted to Plant Phenomics)

Round 1

Reviewer 1 Report

This research paper (plants-2120512) is well presented. I like this manuscript, in special the cost in relation other equipment and very interesting approach combining different technologies for classification-predicted lettuce plants. My only comment for this research is that the inor check speling english in some sentences. The article is well described (introduction, material and methods, the results and discussion) and properly structured. In addition, Alphabetic order in keywords;

Best regards

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Reviewer 2 Report

The article describes the developed inexpensive system for 3D plant phenotyping. The article is well structured and relevant.

There are a few remarks:

Lines 109-111 should be deleted.

Add an abbreviation explanation after the first mention, for example RTK-GPS line 104. Check throughout the text.

Line 132 - indicate the company and country of manufacture. Also for other items, indicate the company and country of manufacture. Check throughout the text.

Figure 7g increase the font height. In my opinion, it is worth adding explanations to the figure in the text.

You should add a subsection - statistics.

Author Response

Please see the attachment.

Author Response File: Author Response.docx

Back to TopTop